Tefcold TM42 User manual

1
Model:
TM32/TM42/TM52
TM32G/TM42G/TM52G
Absorption Minibar
Instruction manual
UK
4
Bedienungsanleitung
DE
10
Mode d’emploi
F
16
Manual de Instrucciones
ES
20
Manual de Instruções
PT
26
Pokyny k obsluze
CZ
32
Kezelői kézikönyv
HU
38

2
UK Contents
Introduction 4
Important Safety Precautions 4
Installation 5
Product Parts and Features 6
How to Operate 6
Reversing The Door 7
Proper Absorption Minibar Care and Cleaning 7
Warranty 8
Disposal 8
Circuit Diagram 9
DE Inhalt
Introduktion 10
Wichtige Sicherheitsmaßnahmen 10
Installation 11
Produktteile und Funktionen 12
Betrieb 12
Türanschlag wechseln 13
Pflege und Reinigung 13
Garantie 14
Beseitigung 14
Schaltkreisdiagramm 15
F Sommaire
Description 16
Déballage 17
Installation 17
Nettoyage 17
Équipement électrique 17
Dégivrage 18
Changement des charnières 18
En cas de panne 18
Élimination 18
Diagramme électrique 19
ES Índice
Introducción 20
Precauciones de seguridad importantes 20
Instalación 21
Partes y características del producto 22
Funcionamiento 22
Cambio del sentido de apertura de la puerta 23
Limpieza y cuidados del minibar de absorción 23
Garantía 24
Eliminación 24
Diagrama de circuitos 25

4
INTRODUCTION
Thank you for purchasing our absorption minibar. This unit is designed to improve your living and
entertaining comfort. The absorption system minibar is a compact, totally silent refrigerator that
uses no compressors or fans. Originally developed for use in hotel rooms, this kind of little
refrigerator is available to use in many other locations, such as cruise line, caravan, department
dormitory, office, etc. With its silent operation and attractive design, you will enjoy the convenience
and comfort for years to come.
Please read these instructions carefully before operating this appliance. When using this appliance,
always exercise basic safety precautions.
This easy-to-use manual will guide you to getting the best use of your absorption minibar.
IMPORTANT SAFETY PRECAUTIONS
Before you use your absorption refrigerator, please read this instruction manual carefully.
Use this appliance only for its intended purpose as described in this owner’s manual.
This absorption refrigerator must be properly installed in accordance with the installation
instructions before it is used.
Never unplug you absorption refrigerator by pulling on the power cord. Always grasp the plug
firmly and pull straight out from the wall outlet.
1) Repair or replace immediately, all electric service cords that have become frayed or otherwise
damaged. Do not use a cord that shows cracks or abrasion damage along its length, the plug or the
connector end.
2) Unplug your absorption refrigerator before cleaning or before making any repairs.
NOTE: If for any reason this product requires service, we strongly recommend that a certified
technician perform the service.
3) Do not operate your absorption refrigerator in the presence of explosive fumes.
4) The power supply must be properly grounded.
5) Do not use an adapter plug or extension cord.
6) Do not use the unit in the immediate surroundings of a bath, shower or swimming pool.
7) Before discarding or storing, we recommend that you remove the door and leave the shelves in
place. This will reduce the possibility of danger to children.
8) Do not store food in absorption refrigerator as the interior temperature may not be cool enough to
prevent spoilage.
UK

5
INSTALLATION
It is advisable to clean the inside of the absorption refrigerator with lukewarm water using a
mild detergent, and then to dry it thoroughly prior to use.
The temperature in the appliance will depend on:
The temperature in the room
The frequency and duration of periods when the door is open.
How many items are in the fridge
It may therefore be necessary to adjust the thermostat from time to time.
The refrigeration system of the cabinet is designed to operate with the cabinet located on a
flat surface. Avoid tilting the cabinet side.
If the cabinet must be tilted on an angle for handling or moving purposes, allow it to sit in an
upright position 20 to 30 minutes prior to plugging it in and starting the cooling of the storage
compartment.
Grounding plug and socket should be provided in accordance with local regulations. The cable-size
should meet the refrigerator’s requirements. The unit must be connected to proper electrical
network, which is shown on the nameplate, through an omnipoplar circuit-breaker. To assure the
proper function of the refrigerator, please observe the following recommended.
1. To ensure the circulation, the unit should be kept at 2 cm, away from the wall.
2. Locate the unit away from direct sunlight. This will enable you to obtain the best performance
and save energy.
3. Under no circumstances should the top grid be covered by any objest. It will preclude the warm
air from circulating.
Installation Figure

6
PRODUCT PARTS AND FEATURES
HOW TO OPERATE ABSORPTION MINIBAR
1. Insert the power plug into wall outlet.
2. To adjust the temperature turn thermostat knob inside the cabinet.
Automatic Defrosting
These models are with automatic defrosting system.
It defrosts automatically every 24 hours.
Temperature Control
shelf
feet
Lamp
Balcony
The control ranges from 0 to 6. Turn the thermostat knob till you
have the desired temperature. Turn the knob clockwise, from 1 to
6, and you can get a lower temperature.

7
REVERSING THE DOOR
How to reverse the door
Remove the lower hinge by loosening and removing the screws with scredriver.
Carefully lower the door and remove it.
Remove the two screws from the left top hinge position, take the metal part off the hinge
position.
Remove the two screws from the right top hinge and take off the hinge, insert the metal part,
rivet the two screws thereafter.
Take off the lower hinge and fix it to the opposite side.
Take the door. Insert the lower hinge axle into the right bottom hole of the door.
Fix the spare hinge to the left top position of the cabinet. Adjust the door, make it straight and
in alignment with the cabinet.
Note: As the door gasket gets pressed-in during shipment, after reversing the door the gasket might
have to be reset. This will be good for seal to avoid any air escaping. If there is a gap between the
cabinet and the door gasket, set the gasket by gently pulling it out to seal the gap. If necessary, you
are recommended also to use the hair drier to warm the gasket to get rid of the gap.
PROPER ABSORPTION MINIBAR CARE AND CLEANING
Warning:To avoid electric shock always unplug you absorption refrigerator before cleaning.
Ignoring this warning may result in injury.
General:Do not use harsh chemicals, abrasives, ammonia, chlorine bleach,
concentrated detergents, solvents or metal scouring pads. SOME of
these chemicals may dissolve, damage and/or discolor your absorption refrigerator.
1) Remove the contents of the appliance
2) Wipe the inside and outside surfaces with a damp cloth. The addition of vinegar to the
water is good for the prevention of mold and fungus.
3) Wipe all parts thoroughly after the cleaning.
IMPORTANT:
When the absorption refrigerator is not in use it must be completely dry inside to avoid mold
growth (if possible have the door open).

8
LIMITED WARRANTY
As a condition to any warranty service obligation, the consumer must present this Warranty
Certificate along with a copy of the original purchase invoice.
THIS WARRANTY DOES NOT COVER:
1) Damage, accidental or otherwise, to the absorption refrigerator while in the possession of a
consumer not caused by a defect in material or workmanship.
2) Damage caused by consumer misuse, tampering, or failure to follow the care and special
handling provisions in the instructions.
3) Damage to the finish of the case, or other appearance parts caused by wear
4) Damage caused by repairs or alterations of the absorption refrigerator by anyone other than those
authorized by the manufacturer..
5) Freight and Insurance cost for the warranty service
ALL WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANT ABILITY
ARE LIMITED TO CLAIMED DURATION. THE MANUFACTURER DISCLAIMS ANY
LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES.
Disposal
Disposal of the cabinet must take place in an environmentally correct way. Please note existing
regulation on disposal. There may be special requirements and conditions which must be observed.

9
CIRCUIT DIAGRAM