tekkiwear SC632 User manual
Electric microcrystallograph – SC632
USER MANUAL
Parts Name
1. Adjustment of speed and ON/OFF; 2. Adjustment of needle length; 3. Needle connect; 4.
Needle catridge
How to Operate
1. Usage method
1) Clean skin: daily make-up removal, cleansing, can use toner for secondary cleaning.
2) Take out the nanowafer and install it on the top of the m i crocrystallizer.
3) Apply proper amount of liquid or essence to your face.
4) Press the power switch key for 3 seconds, start the microcrystallograph, and contact the skin
vercally. Each contact point is recommended to stay for 35 seconds.
5) Aer the operaon, please turn o the power supply and remove the nano chip, apply the
common skin care products, and recommend the use of essence rice. Make a sterile repair mask
before applying skin care products.
6) Nano chip can not be used repeatedly, so as to avoid two mes of polluon.
Instrument operaon
1) Long press start/shut down, default rst blue light is on, click the buon to switch gear
cyclically aer start, second green light is on, third red light is on.
2) Charging display red light, full charge display green light.
How to Operate
Preparaon
(1) Take out needle cartridge in the sterilized packing.
(2) Fing round slots 1 into 2 of machine, push needle cartridge horizontally up to the end.
(3) Lock the cartridge by turning it to the counter clockwise
(4) Adjustment of needle length should be done aer turn on the machine
(5) If you want to remove the needle cartridge, turn it to the clockwise and push out horizontally,
ng round slots ( slot 1 and slot 2 ) together.
Adjustment of needle length
You can adjust the length of needle by turning the adjustment ring clockwise or counter
clockwise. Turning it clockwise, length of it will be longer. Turning it counter clockwise, length of
it will be shorter.
1. Counter clockwise: Lenght of it will be shorter.
2. Clockwise: Lenght of it will be longer.
Manipulaon techniques
Point method: When the microcrystallograph is installed, the nanowafers are vercally touched
on the skin surface, and a slight depression can be observed visually, with a gentle and dense
upper and lower edge. Adjust the strength according to the contact posion
Sliding method: When the microcrystallograph is installed, the microcrystalline wafer is vercally
touched on the skin surface, and a slight quadruple-pit sensaon can be observed visually. While
sliding in a straight line, the nanowafer does not leave the skin surface. It is recommended to
stay at the same part for 3-5 seconds and no more than 2 mes.
Circle method: When the microcrystallograph is installed, the nano-wafer is perpendicular to the
skin surface. It can visually detect the sense of retracon. The nano-wafer is circled at a uniform
speed and does not leave the skin surface. It is recommended that the nano-wafer stay at the
same place for 3-5 seconds and no more than 2 mes.
Maers needing aenon
Notes for nano-electric microcrystallograph:
1) Please do not disassemble or ret chargers and microcrystals. It is strictly forbidden to use
chargers when the power supply is damaged rst. Otherwise, it will lead to electric shock, re
and charger damage.
2) It is strictly forbidden to contact charger with wet hands. If charger touches other liquids in
water and re, it should cut o the power supply immediately.
3) No short-circuit charger, no mechanical vibraon or shaking charger, no direct sunlight, no
bathroom and other high-temperature places to use charger, the equipment is not waterproof,
no rain or damp.
4) Please do not use chargers near TV, radio and other electrical appliances.
5) Pay aenon to the charger when plugging in and pulling the power cord will damage the
wire. When charging, the microcrystallizer and charger must be placed in the venlaon place
with the temperature of - 10 C + 55 C. Using the unauthorized charger can cause danger, and
also violate the warranty terms spulated by the manufacturer.
6) Please keep the charger out of the reach of children to avoid danger.
Notes for nanoneedles
1) If the disposable packing is incomplete and leaky, please do not use it to avoid skin
contaminaon.
2) Before operaon, the operang parts and hands should be clean and clean.
3) For the rst me, it is recommended to do a skin test with iskin care products on the inside of
the wrist. Do not use it if itching and other allergic . phenomena occur.
4) The funcon of the needle to exert moderate force, not to.press intenonally, nor to li the
wrist intenonally unl the wafer can not even touch the skin.
5) About 10-20 minutes aer the use of nano-wafers, some people will have skin redness,
whichis a normal phenomenon and will disappear within 24 hours without treatment.
6) Except for the needle head, no contact with i water or other liquids is allowed in other parts
of the instrument in order to avoid damaging the machine.
7) The same needle can only be used by one person for one me. It is strictly forbidden to share
one wafer with others. It is forbidden to use the same wafer many, mes aer disinfecon.
Otherwise, it may cause skin allergies, red feet, spots, inammaon and other adverse
consequences.
8) When preserving nanoneedles, discard used wafers and store unopened needles and
microcrystallographs. in a well-venlated environment to avoid dampness, heavy pressure, and
shock, and stay away from children.
9) In the process of use, the nano-wafer should move connuously and stay at the same part for
3-5 seconds and no more than 2 mes.
Suggesons for the use of Dry and sensive skin:
Before using all kinds of ecacy products, rst three importe products (hyaturonic acid
replenishment mask and aer skin does not need water, then e fecve products will be imported.
Before introducing eecve products, small-scale introducon should be made. Skin is not red,
swollen, itchy and other symptoms, and then used in the face.
Please use the wash-free repairing and rehydrang products in me aer importaon.
Suggesons for skin with spot problems:
Freckle essence combined with replenishment products, such as whitening and freckle essence,
is used.
Skin with acne problems: It can be imported with acne products, acne skin i itself has
inammaon, it is recommended not to use the whole face back and forth when imporng, only
in the place of acne, so as to avoid infecon of other _parts of the face.
Print Import Note: It can be imported with acne removing products and freeze-dried powder.
First use freeze-dried powder to import the pockmarks. When imporng, avoidinfecon
bypassing the i operaon of the pockmarks, nally, introduce the an-acne products vercally
on the Sockmarks.
Specic manipulaon of acne pit: Aer cleaning the face, rst use the instrument to point on
the pit, then apply freeze-dried powder on the pit, and then use the instrument to point unl
the pit is red or slightly painful. Two mes a week, daily morning and evening smear frozen
thousand powder, generally connue to use for more than three months, the eect is more
obvious.
Table of contents
Other tekkiwear Personal Care Product manuals
