Tekmand Fader Wing User manual

Dimension
Product Introduction
--4
Panel introduction
4
35
126
MAINS SWITCH MAINS INPUT

Technical Feature
Function Feature
Technical parameter
--7
1
2.
3.
4.
5.
6.
.real-time control of 2048 parameters (up to 65536 parameters after
connecting to Tekmand system)
4 DMX in/out
15 pcs executing faders, 60pcs executor buttons
2 USB interfaces
Available to connect to TEKMND onPC system via USB
Independent adjustable backlit button
1 Power AC100-240V, 0.09A,50/60 Hz
2 Max power 5W
3IP IP20
4 Working Temperature -10 40º
5 Dimension 354x320x64
6 Package: carton, 1pc/ctn
7 Net weight 2.2KG
.：
.：
.：
.：～
.：
.
.：
Note: The remark of “Only adapted in the area that is below the altitude height of
2000m” or similar warning remarks should be pasted in the obvious place on the
equipment which can only be used under the altitude height of 2000m, such as the
following:

MAINS SWITCH MAINS INPUT
Safety Lock Connection
Hard Ware Connection
--9
Equipment connection
Power DMX magnifier
Because the product is small in size, a safety lock is made to prevent the
controller from stealing. A safety rope is suggested to purchase to avoid stealing
when the user leaves.
Terminal plug
MAINS SWITCH MAINS INPUT

--11
Brief introduction
1.Make sure the computer installs Tekmand On PC 3.3.0.12 before operation.
2.
3.
Connect the computer to the fader wing via USB cable. Use Zadig to install the
driver.
Open the Tekmand On PC software, press “SETUP” and a dialogue will pop up
which shows the connection is successful.
4 LED backlit brightness: Keep all faders in a
programme, and then push these faders to the top. Enter SETUP/Controller/Lighting
operation interface, scroll up/down “EXECUTOR LED ”bar to adjust the brightness
from 0% to 100%.
5 Fader: Enter SETUP/Controller/Hardware Detect operation interface, push the
fader and the value will be the same as the percentage in the fader bar shown in Pic
two.
6.LED light full off : Enter SETUP/Controller/Hardware Detect operation interface,
click “control all LED” , all LED should be full on/off.
Pic One
.
.
on the lower middle keyboard

--12
Pic Two
8.User Login” Click TOOL window to select LOGIN and a login window will pop up.
Then enter the user name and password like the following:
Note:：
3.
1. The user should read the user manual before operation.
The ambient temperature should not exceed 40 ° when using the console.
Avoid to used it under the humid or dusty environment.
Store it in the clean and dry environment. Keep the power cable in good
condition and do not let the power cable crack.
4. Pay attention to heat dissipation after operation for a long time.
；
2.
7.Dimmer Wheel: Enter SETUP/Controller/Hardware Detect operation interface,
rotate the wheel, the value will be the same as Pic two.