WARNINGS&RESTRICTIONS
INSTALLING, CONNECTING AND MOUNTING
l Allow only licensed or qualified personnel to install the product.
l Switch the power supply off to the receiver before connecting the equipment.
l Check that you have connected the power supply to the correct connection ter-
minal.
l To utilize the safety of the system, use the stop relays in the safety circuitry of the
object that you want to control.
l Use undamaged cables. No cables should hang loose.
l Avoid installing in areas affected by strong vibrations.
l Place the receiver well away from wind, damp and water.
l Cable glands and vent plugs must face down to prevent water from seeping in.
THE USER
l Make sure that the user is following the instructions.
l Make sure that the user has reached the certified age of your country to operate
the equipment.
l Make sure that the user is not under the influence of drugs, alcohol and medicines.
l Allow only qualified personnel to have access to the transmitter and operate the
equipment.
l Make sure that the user does not leave the transmitter unsupervised.
l Make sure that the user always turns the transmitter off when not in use.
l Make sure that the user keeps a good overview of the work area.
MAINTENANCE
l Use the stop button to start and turn off the transmitter as often as possible.
l When error messages are shown, it is very important to find out what caused
them.
l If the stop button is mechanically damaged, contact your representative for serv-
ice immediately.
l Always contact your representative for service and maintenance work on the
product.
l Write down the serial numbers of the receivers and transmitters used. This infor-
mation should be recorded on the “Settings document” for your product (down-
load from our website).
l Avoid registering transmitters to receivers where it is not being used.
l Keep the safety instruction for future reference. Always download the con-
figurations instruction from our web site for the latest version available.
-3-
