Teltonika GH5200 Installation and user guide

https://wiki.teltonika-gps.com/view/How_to_read_data_from_TZ-BT04/05/05B_sensor_with_GH5200_
device
How to read data from TZ-BT04/05/05B
sensor with GH5200 device
Main Page > Autonomous Trackers > GH5200 > GH5200 FAQ > How to read data from TZ-BT04/05/05B sensor
with GH5200 device
Contents
1 How to read data from TZ-BT04/05/05B sensor with GH5200 device
1.1 Solution applies for these SAS devices
1.2 Configuration
How to read data from TZ-BT04/05/05B sensor with GH5200
device
Solution applies for these SAS devices
| TMT250 | GH5200 |
Configuration
These are instructions on how to easily read data from TZ-BT04/05/05B Bluetooth LE sensor with
GH5200 device.
First the GH5200 device Bluetooth settings need to be configured. These are the required steps:
Press Bluetooth settings.
Turn on BT Radio by pressing Enable (hidden) or Enable (visible).
Press Bluetooth 4.0 settings.
Select TZ-BT04/05/05B sensor in BLE connectionless functionalities section.
Type your TZ-BT04/05/05B ID in ID field.
After all these steps press Save to device to save configuration.
To start BLE scan right away press Discover BLE.

More information about these settings can be found on GH5200 Bluetooth 4.0 Configuration modes
page.
To check if the GH5200 device has already received data from TZ-BT04/05/05B Bluetooth LE
sensor, follow these steps:
Navigate toStatus section.
Press I/O Info and look if BLE Temp, BLE Battery and BLE Humidity has any values.