Tennant Pro 2.0 User manual

Quick Start Guide
Pro 2.0
www.senergy.us | [email protected]

DOC 600-001 Effective Date: 09/17/2006
Revision: G Revision Date: 08/26/2013
©2007 Jerry Tennant, MD and
Senergy Medical Group
All rights reserved
Please Keep this Guide handy
and refer to it often
Care & Use of Your New
Tennant Biomodulator® Pro 2.0
For educational purposes only

Table of Contents
About this Guide………………………………………………………………………………….1
Batteries………….…..…………….……………………………………………………………..2
Statement of User Responsibility……………………………………………………………….3
Contraindications………………………………………………………………………………….4
What is an Electrode……………………………………………………………………………..5
Care of Device………………………………....……..……………………………………….…6
Can I do too much?............................................................................................................7
Powering on the Device………………………………………………………..……………….8
Accessory Port………………………………………………………………….……………….9
Diagram – Front……………..………………………………………………………………….10
Diagram – Back.…………………………………………………………………………….….11
Mode Selection…..………………………………………………………………………….…12
Left & Right Arrows………….…………………………………………………………..........13
Modes.……….………………………………………………………………………....…..14-17
Assess Mode……….…………………………………………………………………………18
Understanding Voltage Readings…………………………………………………………...19
Automatic Mode………………………………………………………………………………20
How to Use Power…………………………………………………………………………….21
Fine Tune Power Setting…………………………………………………………………..…22
Graft of Power Curve………………………………………………………………………....23

Table of Contents
Reaction Technology….……..………………………………………..………….………………24
Coefficients of Ongoing Reaction with Biofeedback………………………….………………25
Step by Step Using Your Device…….…………………………………………..…………..26-29
Treating Pain……………………………………………………………………….……………..30
Measure and Treat Each BioTerminal Point……………………………..…….……….……..31
Chart to Measure BioTerminal Points…………………………………………………………..32
Measuring Voltage Tips……………………………………………………….……………..33-34
Balancing Autonomic Nervous System………………………………………....………….35-38
Activating Primary Power Circuit…………………………...…………………..………………39
Using Biomodulator for Extended Time……………………………………….……………….40
Optional Attachments……………………………………………………………………………41
Electrodes Attached with Wires………………………………………………………………..42
Improve Total Body Voltage………………………………………………………………...43-44
Chart Showing Where Black and Red Leads Go When Using Electrode Pads……...…..45
Troubleshooting Voltage Readings…………………………………………………………….46
Simple Daily Treatment…………………………………………………………………………47
Things to Remember………………………………………………………………………….…48
Register for Conference …………..……………………………………….…………………...49
Warranty…………………………………………..……………………………………………….50
FDA Classification…….………………………………………..……………………………..….51

DOC 600-001 Effective Date: 09/17/2006
Revision: G Revision Date: 02/14/2022
©2007 Jerry Tennant, MD and
Senergy Medical Group All rights reserved For educational purposes only 1
About this Users Guide
• Please read all information in this guide and refer to it often.
• This material is intended to provide you with instructions to get you
started using your device immediately. Dr. Tennant’s daily protocol is
very easy to follow and is the best way for all people to get started
using their device.
• Please carefully read the Contraindications before using the device on
anyone.
• You are encouraged to attend our health conference, as a way to
confirm you have all the answers for using your device optimally. You
will also gain a much greater understanding of how and why this device
helps the body improve at the cellular level.
• You should NOT use your device in a professional therapy setting
without having an in-depth understanding of proper use and
contraindications.
• You should call the Senergy office for support of your device. Support
does not include medical advice.

For educational purposes only 2
Batteries
•Tennant BioModulator®uses 2 AA alkaline batteries included with the device. It is
important to only use new batteries that are the same brand.
•Do Not mix old and new batteries, as this can cause them to leak. Battery
corrosion can destroy your device.
• When ON/OFF switch is in the ON position, device is still powered on and battery
life is being used.
• The device is programmed to go into sleep mode after one hour, to save battery
life. To wake it up again push the (+) button.
• Device will signal you that the batteries are running low by a series of
consecutive beeps or by switching back to the Assess mode, and low battery
message in display. Please change your batteries when you see this message.
• If you replaced the batteries and it is still beeping, go buy a new package of
batteries and replace both batteries with new ones.
•Very Important – Remove the batteries if you are not using your device regularly.
When batteries are left in the device for months without use, batteries can leak,
and this can destroy your device.

For educational purposes only 3
Statement of User Responsibility
• You have obtained your Tennant BioModulator® PRO 2.1 either
because you are a licensed healthcare professional or because you
have a prescription for the device on file with Senergy Medical Group.
• The use and care of the device is solely your responsibility.
• Examples provided by other users are for informational purposes only
and are not a substitute for the advice provided by your own physician
or any other medical professional.
• Examples are to give you more information to make informed decisions
and to empower you to take charge of your own health.
•The power is in your hands. Your health is in your hands.

For educational purposes only 4
Contraindications
• These only pertain to using the Tennant BioModulator® with the
electrode directly on the skin. When we are using the Tennant
BioTransducer® none of this is relevant.
• Do not use with pacemaker without permission of cardiologist.
• Avoid direct contact with any implanted electronics in the body.
• Do not use on a stroke patient until a possible blood clot has had
time to resolve.
• Do not rub device over a vessel that might contain a blood clot,
e.g., a tender varicose vein or the carotid arteries.
• Do not use when someone is under the influence of alcohol or
street drugs.
• Do not use electrode directly on eyeball.
• Do not use during pregnancy (for liability reasons)
• Do not use on a patient who is very sensitive to electromagnetic
frequencies,e.g., someone who can’t be around a computer.
• Do not use on a patient who doesn’t want you to use it.

What is an Electrode
• An electrode is something that transmits a current through it, to bring
frequencies from the Tennant BioModulator® into the body.
• The metal on the back of the device is an electrode.
•All of the conductive attachments that plug into the device like the foot
plates and hand grips, Y electrode, electrode pads that stick on the
skin, are all electrodes.
• Electrodes are conductive, this means that you must have skin contact
to use them, and you will feel a sensation with that skin contact.
• If you are not feeling any sensation from an electrode attachment that
you have plugged into the side port of the device, you may have a bad
wire.
•The Tennant BioTransducer® is the only attachment that plugs into
the Tennant BioModulator® that is NOT an electrode, and so you do
not need skin contact and you do not feel any current.
For educational purposes only 5

For educational purposes only 6
• Don’t turn on if below freezing.
• Clean electrode only with a 70% isopropyl alcohol .
• Do not leave your device in a hot car in the summertime.
•Do not try to open your device; doing so will void your warranty.
Care of Device
Electrode corrosion can occur
If not cleaned regularly.
• Device can be damaged to the point of non-function if dropped on
hard surface. (a protective carrying case is recommended)
• Device WILL be damaged beyond repair if dropped in water or
liquids are spilled inside.
• The battery compartment slides off and on the device. Do not force
the battery cover.
• Be careful when attachments are plugged into the port. Damage
can occur inside the port if there is too much movement at the plug.
• Always unplug wires from the accessory port and store device in
protective case.
Your Tennant BioModulator®PRO 2.1 has software and
advanced circuitry like a computer, it is important to
remember this when handling your device.

Can I do too much?
• You can use the device for long therapy sessions when you have the
need. There may be times when you are in pain from a serious injury,
and you need to use it longer to help your body to heal.
• It is important to listen to your body.
• If you feel the current from the electrode is strong, turn it down. It
should feel gentle, just a slight vibration.
For educational purposes only
7

For educational purposes only 8
The ON-OFF switch is on the side of the unit. Slide the
switch up to turn it on. Slide the switch down to turn it off.
Turn Tennant BioModulator®PRO 2.1 On

For educational purposes only 9
Accessory Port
Accessory port on
top right corner of
unit.
This port should be
used for authorized
accessories only!
Do NOT force anything
into this port or the
warranty may be
voided.
Always unplug wire
when not in use.

Diagram –Front
For educational purposes only 10
On / Off switch
Blue light indicates
power is on
Power level control
Accessory port

For educational purposes only 11
1. Built-in electrodes on back of unit.
2. Battery connectors: Only use alkaline AA batteries.
3. Serial number
4. Calibration/programming connector – Do not damage or insert anything.
Very important to keep the battery compartment clean and dry.
Diagram –Back

For educational purposes only 12
Mode Selection with
Tennant BioModulator®PRO 2.1
Navigation Keys
You may use the up
or down buttons to
scroll thru the modes.
When using the down
arrow button, you will
find all of the modes
in the order as they
are listed on the
program description
sheet.
When you have
reached the
mode, you want
YOU MUST
select it with the
middle button.

Left and Right Arrows
For educational purposes only 13
The left arrow takes you
to
the Reaction (R) option
when you are using one
of the following modes;
Assess, Ten-8™,BT
frequencies
CH frequencies,
individual
frequencies and AVA™
modes.
The right arrow takes you to
the option of fine tuning
your power settings.
This lets you to increase
the power using baby steps.
These buttons take you to sub-menu options for advanced users.
Ignore these buttons if you are a beginner.
Advanced Function Keys

Tennant BioModulator® PRO 2.1 modes
• On the next few pages is a list of operating modes. The modes are
programed with frequencies as well as patterns in which the frequency
is delivered. You will notice that some modes have a wide range of
frequencies, and some have just one frequency. When using a mode
with just one frequency the intent is to give a focused frequency for
shorter therapy like 5-10 min. When using a mode with multiple
frequency changes, therapy can go on for many hours if needed.
• Modes which feature Reaction technology are indicated by (R) When
you are using one of the modes that have the Reaction you will see a
number appear in the center of the display screen. This number is the
voltage reading and is referred to as the initial reaction.
• Modes that have an * are Dr. Tennant’s proprietary frequencies.
• Any mode can be used with any attachment. An attachment is
something that is plugged into the side of the Tennant BioModulator®
to help facilitate a therapy. Examples of attachments used most are
foot plates & hand grips, Y electrode and the Tennant BioTransducer®.
For educational purposes only
14