Thrane&Thrane SAILOR 900 VSAT System User manual

QUICK GUIDE
Introduction
The SAILOR 900 VSAT system has been
configured during installation with all needed
satellite and modem profiles. After startup it
uses the last selected satellite profile.
To change to another satellite (or modem pro-
file), or change an antenna parameter, connect
a PC to the Antenna Control Unit (ACU) and
enter the built-in web interface.
Setup and configuration
1. Switch on the SAILOR 900 VSAT at the power
switch of the ACU.
2. Connect a PC to LAN port 3 (Rack version:
Front LAN connector) of the ACU, use a
straight Ethernet cable.
3. Enter the address http://192.168.0.1 (default)
in your Internet browser. The built-in web
interface opens
directly with the
DASHBOARD.
4. Click SETTINGS and
activate the new
satellite profile.
For detailed information see the SAILOR 900
VSAT Installation & user manual.
SAILOR 900 VSAT

Navigation
1. Switch on the SAILOR 900 VSAT at
the power switch of the ACU.
2. Use the arrow keys on the keypad
of the Antenna Control Unit (ACU)
to go to a menu.
3. Press OK, then the arrow keys on
the keypad to select a parameter.
The current menu name is shown
in the upper left corner of the
display.
For changing a parameter in the
SAILOR 900 VSAT use the built-in web
interface of the ACU. See overleaf
for a short introduction to the web
interface.
Resetting the ACU
1. Press and hold the arrow up and
down keys until the ACU display
shuts down and the ACU reboots.
2. Wait until the system has rebooted
and is operational again. The
last active satellite profile will be
selected.
For detailed information see the SAILOR
900 VSAT Installation & user manual.
98-133401-D
thrane.com
SAILOR 900 VSAT
Viewing system parameters
MAIN
ANT
ANTENNA
MODEM
NETWORK
SATELLITE
EVENTS
POINTING
POLARIZATION
GPS
HEADING
VERSIONS
SERIAL NUMBERS
EVENT
<EVENT 1>
<EVENT 2>
<EVENT 3>
<EVENT 4>
SAT
POSITION
RX POLARIZATION
TX POLARIZATION**
RX FREQUENCY
LNB LO **
TX FREQUENCY
BUC LO
NET
PORT 1/2 IP
PORT 1/2 MASK
PORT 3 IP
PORT 3 MASK
PORT 4 IP
PORT 4 MASK
DEFAULT GATEWAY
ANT-2
RX POLARIZATION
TX POLARIZATION
ANT-1
ANTENNA STATE
ELEVATION
AZIMUTH
ANT-3
LATITUDE
LONGITUDE
FIX TYPE
MODEM
MODEM/TYPE
TX ENABLE
RX LOCK
SIGNAL LEVEL *
ANT-5
SW VERSION
ANT-6
ACU
ADU
SAT
* for some modems
** for some antenna configurations
ANT-4
HEADING