Tescom TM845 User manual

MixerUser manual
TM845
TESCOM

1Shipped components
Lid
Mixer Bottle
Maximum (1000ml)
750ml
500ml
Minimum (300ml)
Packing
Cutter
Bottle stand
Installation guide
Body
Flash switch
Power switch
Power code
Power plug
cover
Power plug
Safety switch
reset button
Bottom
Safety switch pin
Safety switch pin
Safety switch pin
Rubber cover
Back
Surface
Match

Match
2Installation
2. 1 Assembly/Disassembly
Lay the assembly in the order shown below
Lid
Mixer bottle
Packing
Cutter
Bottle stand
Installation guide
Body
Bottle stand
Disassemble by turningthe
bottlestand as shown below
•Fix the packing firmly
•Handle the cuttersafely
•Fix the cutterfirmly to the bottlestand
!WARNING

Handle
Lid
Lib
Groove
Body
2Installation
2. 2 Storage
You can store the mixer bottle compactly as
shown below
!•Store the body after drying
•Firmly remove the oil on the lid
WARNING

Off
3Operation
3. 1 How to use the mixer
1. Put the material in the mixer
2. Confirm that the power switch is set to “Off”
3. Fit the recess of the bottle base with the
protrusion of the main body
4. Plug the power plug into an outlet
Maximum
amount
Minimum
amount

3Operation
4. Press the flash switch several times with a
length of about one second
5. Turn on the power switch
6. Turn off the power switch when it becomes
your favorite condition
Off On Flash
Off On Flash
FlashOnOff

4Maintenance
4.1 Mixer bottle/Packing
1. Put lukewarm water to one third
2. Put a few drops of detergent to operate
3. Remove them and wash them
4. Drying
4.2 Body
•Wipe off the soiling with a soft cloth

4Maintenance
4.3 Cutter/Bottle stage
•Remove packing
and rinse thoroughly, drying
•Wipe off rubber cover with dust
!Do not spray water directly on
the rubber cover of the bottle,
and do not put it on it
WARNING

5Trouble shooting
•How to cut materials is too big >>>Cut materials small
•Too much materials>>>Reduce the amount of material
•Ice is crammed in>>>Remove pinched ice
•Motor protection device worked>>>Press the reset
button
Vibration is large.
The cutter rotates slowly or does not turn.
Operation stopped.
•Mixer bottle and bottle stand are not
tightened>>>Disassemble and reassemble
•Packing is not installed correctly>>>Correctly install
packing
Water leaks

5Trouble shooting
Smoke is generated.
The cord twisted and came back.
•Consult your dealer or the Authorised Service Agent.
Can not turn on.
•Safety switch not pushed >>>Assemble correctly
•Motor protection device is still working >>>Press the
reset button
•The power plug is disconnected>>>Plug the power
plug into an outlet

6Index
1. Shipped components
2. Installation
2.1 Assembly/Disassembly
2.2 Storage
3. Operation
3.1 How to use the mixer
4. Maintenance
4.1 Mixer bottle/Packing
4.2 Cutter/Bottle stage
4.3 Body
5. Trouble shooting