Recording the image
1Freeze image: Press trigger button once.
2Save image: Press trigger button again.
or
Discard image: Press [Esc] .
Switching on / off
Remove protection cap from the lens.
Switch on: Press [ ] .
- The measurement view is opened after the
warm-up period.
- The thermal imager performs an automatic
zeroing approx. every 60 sec. This can be
recognized by a “click”. The image is frozen
briefly when this occurs.
Switch off: Press [ ] again.
Focusing the picture
With motor focus
1Switch on motor focus: Slide motor focus
switch towards the display (position ).
2Focus: Move motor focus control to the
left / right.
Manual
Caution! Manually turning while motor focus is
switched on damages the auto mechanism.
Switch off motor focus: Slide motor focus
switch towards the lens (position: ).
Turn lens by hand.
