Texecom Premier Elite Impaq Plus-W User manual

Technical Support : 91520 10269 : [e-mail]
Press 1234 on the control panel. The below message will be displayed.
Press Yes
Press reset button
When it starts learning you need to insert the battery into the Impaq plus-W
Premier Elite Impaq Plus-W (GBB0003)
Press Yes till you reach zone type
Note: In this case
we’re learning
sensor in zone 10.
Press any free zone number (eg: 010) to learn your Impaq plus-W
Note: Before learning the
sensor we need to place
the jumper in relearn

Technical Support : 91520 10269 : [e-mail]
Press Menu ( ) two times on the control panel and then press Yes to logoff
from your control panel
Frequently Asked Questions:
1. How to enable reed?
Ans: Inside the device we have an option for reed enable & disable. Below
image will give you an idea for place magnetic contact distance.
Press Yes 7times to reach zone mode(wiring) & make zone wiring as
“always awake”
3. How to adjust the range?
Ans: Inside the device we have an option for adjusting the range of sensor with
2 pins inside & below image is for your reference.
2. What would be the maximum distance between the device and magnetic
contact?
Ans: The magnetic contact distance is
Non-Ferrous
Mounting Material
Ferrous Mounting
Material
Maximum Break 30mm 15mm
Minimum Make 15mm 5mm
4. How to adjust the sensitivity of the vibration in this device?
Ans: Inside the device we have an option for adjusting the sensitivity. If we
adjust the sensitivity in clockwise direction, it will increase the sensitivity & in anti-
clockwise direction, it will decrease the sensitivity of the sensor.

Technical Support : 91520 10269 : [e-mail]
5. How to identify the LED status of sensor?
Ans: Below are the detailed details of the LED status.
Colour Status Description
Flashing
Green
Comfort LED. When the reed switch is closed, the comfort
LED will flash green approximately every 3sec to indicate
correct operations.
Momentary
Green
Background disturbance/under-sensitive setting. This is
used to indicate background disturbances or an under-
sensitive setting during installation.
Momentary
Red
Alarm condition/correct sensitivity. This is used to indicate
that an attack has been detected by the shock sensor or
a correct sensitivity setting during installation.
Momentary
Orange
Gross attack /over-sensitive condition. This is used to
indicate that a massive attack has been detected by the
shock sensor or an oversensitive setting during installation.