Texecom Premier Elite SmartKey User manual

Technical Support : 91520 10269 : [e-mail]
Connecting Keyfob
Power
Arm
Part arm
Disarm
LED Status
Disarm
alarm
Status
led
Arm alarm
Status led
Part arm
alarm
Status led
Press 1234 on the control panel. The below
message will be displayed.
Press 8 to reach “Setup Users”
Press Yes (Will show you the free User as below)
Press arrow button ( or ) to select the required User
Press Omit button ( ) to select the required User
Press No button ( X ) it will start learning process
During this learning process you need to power on the keyfob by holding the
power button for 4 seconds. once the device is learned will show as below.
Press Menu ( ) three times on the control panel and then press Yes to logoff
from your control panel
Note: In this example, we selected
Master user
Premier Elite SmartKey (GCC0012)

Technical Support : 91520 10269 : [e-mail]
FAQ:
1. How to arm the alarm panel through Keyfob?
a. Power on the keyfob by holding the power button ( ) for 4 seconds.
b. LED status will show in Blue colour.
c. Press & hold for 2 seconds with arm button ( ).
d. Then Arm LED status will indicate in Red colour.
3. How to part arm the alarm panel through Keyfob?
a. Power on the keyfob by holding the power button ( ) for 4 seconds.
b. LED status will show in Blue colour.
c. Press & hold for 2 seconds with Part Arm button ( ).
d. Then part arm LED status will indicate in orange colour.
Note: The SmartKey will power off after 20 seconds of no activity.
5. How to identify the Alarm Status LED’s?
a. Green LED on = Disarmed
b. Orange LED flashing = Part Arming
c. Orange LED on = Part Armed
d. Red LED flashing = Arming
e. Red LED on = Armed
f. All 3 LED’s flashing together = Alarm
g. All 3 LED’s cycling = Panic Alarm
2. How to disarm the alarm panel through Keyfob?
a. Power on the keyfob by holding the power button ( ) for 4 seconds.
b. LED status will show in Blue colour.
c. Press & hold for 2 seconds with disarm button ( ).
d. Then disarm LED status will indicate in Green colour.
4. How to activate panic alarm through keyfob?
a. Power on the keyfob by holding the power button ( ) for 4 seconds.
b. LED status will show in Blue colour.
c. Press and hold disarm ( ) & power ( ) button together for 4 secs.
d. All 3 LED’s will start flashing together.