Texsport 15155 User manual

INSTRUCTIONS
Item 15155 • Picnic Table Set
Thank you for purchasing this Texsport picnic table set Please read and understand each step of the set-up instructions We
encourage you to set-up this picnic table set at least once prior to your camping trip, ensuring that you have a satisfactory
understanding of the set-up process We hope you enjoy your new picnic table set and that it will give you many years of
camping pleasure
Do not apply excessive force to this product.
TEP 2 - Unlock and open
case.
TEP 1 - Unzip storage
bag and put aside for
later use.
TEP 3 - eparate the
picnic table pieces.
2 benches and
1 table top.
TEP 5 - ecure legs by
locking the latch onto the
leg pin.
TEP 4 - Lift bench legs up
and out to open.
TEP 6 - Unfold table.
TEP 8 - Grasp table feet
and swing out to lock into
position.
TEP 7 - Lift table legs up
and out to open
TEP 9 - Pull legs straight
up and lock with pressure
pins.
15155 Instr ction Sheet 10-10_Layo t 1 10/12/10 8:37 AM Page 1

TEP 14 - Lay storage bag
out and separate the
hook ‘n’ loop straps.
TEP 13 - Flip table over
and slide the locking
device to secure legs.
TEP 15 - Lay bench onto
the storage bag and
secure bench using the
hook ‘n’ loop straps.
TEP 16 - Enjoy your
picninc table set.
MODEL: PICNIC TABLE ET
ITEM 15155
MADE IN CHINA
WF11
ZIPPER :
If zippers stick, lubricate with silicone Never force a zipper which has material
caught in it, as this will bend the slider and prevent the zipper from closing
Continual use in a sandy environment can cause the slider to erode and fail to
close the zipper
TORAGE:
Picnic table set should be stored dry and away from heat and water Never store
directly on concrete, as moisture and chemicals in concrete may damage the
carry/storage bag
WA HING:
Hand wash with a sponge, using a mild soap Never use detergents or washing
machines as they may damage the seams
QUE TION :
If you should have any questions, problems or comments, please call our Cus-
tomer Service Department at
1-800-231-1402 or e-mail [email protected] This Department is open
M–F from 8 a m –5 p m CST
TEP 11 - wing out the
end table top support
arm. Pull table slats out
slightly and insert support
arm into the molded joint.
TEP 10 - This is what
your table look like at
this point.
TEP 12 - Turn the center
table top support arm
and snap into the molded
joints.
15155 Instr ction Sheet 10-10_Layo t 1 10/12/10 8:37 AM Page 2