Page 6
ASSEMBLING THE BLOWER/VAC
1. Connect the top suction tube to the bottom suction tube and screw
them together with large screw.
with large screw
in top of the
square opening of the collection bag onto the square opening of the
5. Ensure the zip fastener is closed on the collection bag!
6. The strap is attached to the machine using the metal triangular clip.
7. Thread the cable through the strain relief feature forming a loop as
shown.
the
position and the collection bag is secure before connecting to the mains
electricity supply.
The On/Off switch is located on the underside of the rear handle and is
operated by pressing and holding the switch to turn On and releasing to turn Off.
Never
Using as a Blower:
from side to side a few centimetres above ground level.
near sand, soil, loose gravel or shingle.
To convert to a Vacuum Shredder:
Move the switch to the vac/shredder setting as shown.
the
Switch on and move the machine over the debris slowly.
Suction power decreases when the bag is full so ensure that it is emptied
regularly.
Before emptying disconnect the Blow Vac from the mains.
mode to remove any material still lodged in the suction tubes.