The Land of Nod Cube 6-cube Bookcase User manual

CUBE
6-CUBE BOOKCASE
Made in Thailand - r05 Page 1 of 4
HARDWARE
COMPONENTS
Thank you for purchasing the 6Cube Storage
Bookcase.This page lists all the contents included in
the box. Please take the time to identify the hardware as
well as the individual components to this product. As
you unpack and prepare for assembly, place the
contents on a carpeted or padded area to protect them
from damage.
Note: 2 people are required to safely assemble this product.
Customer Service 800.933.9904 | Latest instructions available on www.landofnod.com
12 - flat
washers
12 - spring
washers
1 - top panel 1- bottom panel
2 - side panels
(1 left, 1 right)
2 - partitions2 - back
panels
1 - middle panel
Missing hardware? Please call 800.933.9904 for replacements.
NOTE: Contains small parts. Keep away from small children.
TOOLS REQUIRED
20 - wood
dowels
phillips head screwdriver allen wrench (included)
(We recommend the use of hand tools instead of power tools)
23 - screws 4 - large
screws
12 - bolts
WARNING: Adult Assembly Required
!

CUBE
6-CUBE BOOKCASE
Made in Thailand - r05 Page 2 of 4
Customer Service 800.933.9904 | Latest instructions available on www.landofnod.com
3
12
4
Position assembly as shown. Fit dowels of
partitions into corresponding holes of bottom
panel as shown. Secure bottom panel with 4
large screws using a phillips head screwdriver.
Do not over tighten the screws.
Insert 6 wood dowels into each side panel as
shown.
With the assistance of another adult, fit slots of
each partition into corresponding slots of middle
panel as shown.
bottom
panel
side
panel
NOTE: Do not
over tighten the
screws
Insert 4 wood dowels into each partition as
shown.
middle
panel
partition
partition
partition

CUBE
6-CUBE BOOKCASE
7
56
Made in Thailand - r05 Page 3 of 4
Customer Service 800.933.9904 | Latest instructions available at www.landofnod.com
Cleaning and Care
Clean surfaces with a dry or damp soft cloth. Do
not use abrasive cleaners. Do not use furniture wax
or polish as the unit is finished with a protective
clear lacquer.
With the assistance of another adult, carefully
place assembled unit upright as shown. Attach
2 back panels to assembly with 23 screws, using
a screwdriver.
Assembly is now complete.
top panel
Fit dowels of partitions into corresponding holes
of top panel as shown.
left
side panel
right
side panel
Fit dowels of left and right side panels into
corresponding holes of assembled unit as
shown. Secure each side panel with 6 bolts, 6
spring washers and 6 flat washers using an
allen wrench.
NOTE: Do not over
tighten the bolts

For added safety and stability, it is recommended that the wall mounting hardware be installed. For safe mounting, it is
essential to use wall anchors appropriate to your wall type (i.e. plaster, drywall, concrete, etc.). Mount to wood studs
whenever possible.
A) Attach mounting bracket to top center of unit using 2 small screws.
B) Determine the final location of unit. Mark position on the wall, approximately 2" below the mounting bracket mounted to
the back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not available, drill a hole in the wall that is slightly smaller in diameter than
the anchor. Gently tap the plastic anchor until the flange of the anchor is flush with the wall.
D) Attach the mounting bracket to the wall by inserting 2 large screws through the mounting bracket and into the wall
anchor in the wall.
E) Place the unit so the mounting bracket on the back edge is allowed with the wall bracket.
F) Lace one end of the wall strap through both brackets, and into the other end of the strap.
G) Pull the strap tightly until secure.
Repeat step A-G for remaining wall mounting assembly.
NOTE: If you are unsure about your wall type or what mounting method you should use, consult a qualified
professional.
Wall mounting assembly is now complete.
A
C
D
small
screw
mounting
bracket
plastic
anchor
large
screw
wall
strap
mounting
bracket
Serious or fatal crushing injuries can occur from furniture
tip over. Use of tip-over restraints may only reduce, but
not eliminate, the risk of tip-over. To help prevent tip-over,
install tip restraint per instructions below.
WARNING
!
Missing hardware? Please call 800.933.9904 for replacements.
NOTE: Contains small parts. Keep away from small children.
MOUNTING HARDWARE
TOOLS REQUIRED
WALL MOUNTING ASSEMBLY
power drill
(for pilot holes only)
phillips head screwdriver
4 - plastic
anchors
2 - wall
straps
4 - small
screws
4 - large
screws
4 - mounting
brackets
CUBE
6-CUBE BOOKCASE
Made in Thailand - r05 Page 4 of 4
Customer Service 800.933.9904 | Latest instructions available on www.landofnod.com
WALL