The Things Products The Things Node User manual

GETTING STARTED WITH
THE THINGS NODE
For full installaon & setup please visit
hps://n.fyi/acvate.
1. Unscrew the enclosure with a screwdriver.
2. Mount the 3 AAA Alkaline 1.5V baeries.
3. Connect a micro USB cable to an USB port of your
computer and to the micro USB connector on the
Things Node.
4. Connue with the steps as described in the
illustrated quick start guide for the Things Node
found on hps://n.fyi/acvate.
INSTRUCTIONS FOR SAFE USE
The Things Node shall only be powered by 3 AAA
Alkaline 1.5V baeries or via micro USB.
The connecon of incompable devices to the Things
Node (f.e. via the micro USB connector) may affect
compliance or result in damage to the unit and
invalidate the warranty.
The Things Node has one of the following modules on
board with the following frequency and output
power;
Frequency
Range
LoRaWAN
915 MHz
Maximum TX
Range
27 dBm902 to 928 MHz
For installaon & set up please visit
hps://n.fyi/acvate
EN

The Things Node operates on the 915 MHz ISM band
using the LoRaWAN protocol.
The Things Node is powered by 3 AAA Alkaline 1.5V
baeries. Manufactured by Premier Farnell and other
companies that are members of the Premier Farnell
group in PRC.
For installaon & set up please visit
hps://n.fyi/acvate
The Things Products
Herengracht 182
1016BR Amsterdam
The Netherlands
Contains FCC ID: T9JRN2903
Contains IC ID: 6514A-RN2903
THE THINGS NODE
Model: TTN-002-915-1.0
This device complies with Part 15 of the FCC Rules.
Operaon is subject to the following two condions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operaon.
This equipment complies with FCC radiaon exposure
limits set forth for an uncontrolled environment. End
users must follow the specific operang instrucons or
sasfying RF exposure compliance. This transmier
must not be co-located or operang in conjuncon
with any other antenna or transmier.
Changes or modificaons not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.