Therabath TB6 User manual

Unpack the unit; place it on a flat,
secure surface.
Pour up to 9 bags of refill paraffin
wax in to the tank.
Place the plastic grille on top of the
unmelted paraffin.
Rest the lid on top of the grille.
(the paraffin will compact as it melts)
Attach plug; plug in the unit.
(the paraffin will fully melt in 6 - 8 hours)
During proper operation, the light turns
on and off regularly (as the unit is
heating), and is mostly off. The light is
not an indication that the wax is melted.
5 EASY STEPS
to get you up and running with your THERABATH PARAFFIN BATH!
www.therabath.com
BEFORE YOU BEGIN, locate and record the Lot Number
found on the bottom of your unit (shown at right).
You will need this to register your warranty.

cleaning
therabath quick tips
1. Clean unit when you see sediment has built up on bottom of inner tank.
2. Unplug unit, remove lid, & grille and allow paraffin to completely harden
overnight.
3. Plug in unit for approximately 10 minutes to melt edges of hard paraffin “cake”
around the inside of the tank. Lay out paper towels to set wax “cake” on.
4. Turn unit upside down (keeping close to table surface). Holding the long
edges of the tank, squeeze the tank outwards away from the wax,
shaking gently until the cake releases and slides on to the
table surface.
5. Blot up remaining paraffin in tank with a soft
paper towel and wipe unit dry. HINT: a hair
dryer will melt hard paraffin drips, then
blot them up with a paper towel.
6. Replace fresh paraffin in the tank,
place the grille on top of paraffin,
and replace lid.
7. Plug in the unit.
8. After paraffin has melted (6-8
hours), add additional wax as
necessary to bring up to required
level.
www.therabath.com
MR#125, rev. 07/18.
Copyright ©2018 by WR Medical Electronics Co. All rights reserved.