Thermo Interceptor User manual

en 5.1(4956) 02–2010
User Manual
Interceptor™
Spectroscopic Personal Radiation Detector

BInterceptor™/en/5.1(4956)/Feb2010 ICx Technologies

Interceptor™
Spectroscopic Personal Radiation Detector
User Manual

This document is changed in accordance with the ICx Technologies Quality
Management system. Changes are archived.
Revision Interceptor™/en/5.1(4956)/Feb2010
Product Interceptor™
Language English (en)
Version 5.1 (4956)
Latest Change February 05, 2010 at 14:04 (UTC+01h)
ICx is a trademark of ICx Technologies, Inc.
ICx Radiation is a trademark of ICx Radiation, Inc.
All other trademarks belong to their respective holders.
Copyright © 2007–2010 ICx Technologies GmbH and ICx Radiation, Inc.
All rights reserved.
ii Interceptor™/en/5.1(4956)/Feb2010 ICx Technologies

Welcome
Thank you for purchasing the I™, the latest generation in Spec-
troscopic Personal Radiation Detectors (SPRDs). This manual is designed to
guide you through configuration, operation and maintenance of your new
equipment.
The I™ is designed to monitor radiation and warn you if an
increased radiation level is detected. The I™ is capable of detect-
ing gamma radiation as well as thermal neutrons (optional). In addition to
the features provided by standard PRDs, the I™ also allows you
to qualitatively analyze a detected gamma radiation source by identifying the
isotopes using a template matching algorithm (optional).
The I™ is equipped with two (2) Cadmium-Zinc-Telluride
(CZT) crystals. These detectors are called finder detectors, and they are used
to monitor the gamma dose rate. For nuclide identification purpose, one (1)
optional high resolution CZT detector is used. For counting thermal neu-
trons, one (1) optional 3He proportional counter is used.
The I™ operates in two main modes: Unattended Surveillance
Mode (USM) and User Attended Mode (UAM). UAM allows you to interact
with the I™, whereas the device runs unattended in USM.
In USM, the device constantly monitors gamma dose rate and neutron count
rate (optional). A green status LED indicates that the device is active and
running. To save power, the display is not powered in this mode. If the user-
defined alarm levels are exceeded, the display is powered up and visual, audi-
ble, and tactile (via vibration motor) indications are given. The display can be
manually switched on at any time.
LED’s, a speaker, a vibration motor, and an optional headset featuring Blue-
Thermo Fisher Scientific Interceptor™/en/5.1(4956)/Feb2010 iii

tooth® technology permits I™ passive usage without constant
user monitoring.
The I™ is powered by an intelligent battery block. Battery status
is displayed at the bottom right corner of the display.
Important Tips
Warning Before using the I™ for the first time or installing
the PC software, read the manual carefully to prevent damage to the I-
™ or the PC. s
Warning Make sure that all components are present, and inspect them vi-
sually for any damage that may have occurred during shipping. Please refer to
chapter 1.1,p.1.s
Warning Make sure to fully charge the I™ before first usage to
optimize the battery capacity. Please refer to chapter 1.2,p.2s
iv Interceptor™/en/5.1(4956)/Feb2010 ICx Technologies

Disclaimer
Thermo Fisher Scientific Corporation reserves the right to make changes to
any product to improve reliability, function, or design and does not assume
any liability arising from either application or use of any product described
herein.
The information presented in this publication has been carefully checked and
is believed to be entirely reliable; however, no responsibility is assumed for
inaccuracies.
Furthermore, the information does not convey to the user any license under
the patent rights of Thermo Fisher Scientific Corporation or others.
Since the I™ encloses parts that are proprietary of secondary
companies, these products may be trademarks of these suppliers.
The data in this manual is considered “proprietary data”. It may be duplicated
and used by or on behalf of the customer with the express limitations. The
“proprietary data” may not be disclosed outside the customer or be used for
any purpose other than the operation of the I™ without prior
permission of the manufacturer.
Thermo Fisher Scientific Corporation assumes no liability for any prohibited
uses that can void the warranty for the I™ unit. Since no user
serviceable components exist within the I™ unit, the unit is
never to be opened by the user under any circumstances. The unit, under
no circumstances, is to be exposed to temperatures exceeding 212°F (100°C).
Warning If the I™ is opened by unauthorized personnel, the
IP60 protection class will be destroyed. Furthermore, removing the back
Thermo Fisher Scientific Interceptor™/en/5.1(4956)/Feb2010 v

cover of the I™ creates a potential shock hazard due to high
voltage present within the unit. Water and dust entering the unit severely
impedes its performance; therefore, this is prohibited, and will void the I-
™ warranty. s
Warning Heating the I™ above 100 °C (212 °F) can cause the
Li-Ion battery to explode or incinerate. This is prohibited, and will void the
I™ warranty. s
Warning This unit contains potentially hazardous materials i.e. the
Cadmium-Zinc-Telluride detectors and a Li-Ion battery. Proper disposal of
the I™ at the end of its service life requires recycling according
to WEEE. s
This disclaimer shall be marked on any reproduction of this data in whole or
in part.
vi Interceptor™/en/5.1(4956)/Feb2010 ICx Technologies

Contents
List of Figures xi
1 Before Getting Started 1
1.1 Parts and Components .................... 1
1.2 Before First Use ....................... 2
2 Usage and Maintenance 3
2.1 Components ......................... 3
2.1.1 I™ Overview ............ 3
2.1.2 Component Descriptions: Front View ...... 3
2.1.3 Component Descriptions: Rear View ....... 5
2.2 Basic Operation ....................... 6
2.2.1 Switching the Device ON ............. 6
2.2.2 Switching the Device OFF ............ 7
2.2.3 Alarm Acknowledgements ............. 7
2.2.4 Wake Up ..................... 7
2.2.5 Charging the Battery ............... 8
2.2.6 Using the External Battery Pack .......... 11
2.3 Main Operation ....................... 14
2.3.1 User Attended Mode ............... 14
2.3.2 Unattended Surveillance Mode .......... 14
2.3.3 Dose Rate, Isotope Identification, and Thermal
Neutron Counting ................ 15
2.4 The I™ Language Configurations ....... 18
2.5 The I™ Unit Hardware Configurations . . . . 18
2.6 Maintenance ......................... 18
2.7 Storage ............................ 19
Thermo Fisher Scientific Interceptor™/en/5.1(4956)/Feb2010 vii

CONTENTS
3 Operating the I™21
3.1 Modes of Operation ..................... 21
3.2 User Attended Mode ..................... 23
3.2.1 Dose Rate Mode and Finder Mode ........ 24
3.2.2 Nuclide Identification (ID) Mode (Optional) . . . 26
3.2.3 Voice Recorder Mode ............... 30
3.2.4 Settings Mode ................... 30
3.3 Additional Modes of Operation ............... 33
3.3.1 Level Mode .................... 33
3.3.2 Timer/Counter Mode ............... 34
3.3.3 Camera Mode (Optional) ............. 35
3.3.4 Advanced Spectrum Mode (Optional) ....... 36
3.3.5 SPRD Mode (Optional) .............. 39
3.3.6 Info Mode ..................... 40
3.3.7 Bluetooth® Mode (Optional) ........... 41
3.4 Bluetooth® GPS Mode (Optional) ............. 46
3.5 Bluetooth® Reach-Back Mode (Optional) .......... 49
3.5.1 Reach-Back Push Using Modem/DUN ...... 50
3.5.2 Reach-Back Push Using RS232 Device ...... 52
3.5.3 Reach-Back In Monitor/Heartbeat Mode ..... 53
4 PC Software 55
4.1 Disclaimer .......................... 55
4.2 Recommended Operating System .............. 56
4.2.1 I™ Sync and Microsoft Vista . . . . 56
4.3 Before Getting Started .................... 57
4.4 Installing the PC Software .................. 58
4.4.1 Upgrading from previous installations of I-
™ Sync .................. 59
4.5 Remarks on Microsoft® ActiveSync® ............ 60
4.6 Remarks Regarding the Usage of USB Hubs ......... 61
4.7 PC Software Remarks .................... 62
4.8 Software Updates ...................... 63
4.9 First Start - Application Settings ............... 64
4.9.1 Preferences .................... 65
viii Interceptor™/en/5.1(4956)/Feb2010 ICx Technologies