Thomasville Crystal Bay 5000048-0106102 User manual

Thank you for purchasing this quality product. Be sure to check all packing materials carefully for
small parts that may have come loose inside the carton during shipment. Please read all
instructions carefully before starting the assembly process.
CAUTION: Some items and/or the components are cumbersome and heavy. Therefore, the
assistance of one or more people is recommended in order to prevent personal injury and insure
that the item and/or its components are not damaged during the assembly process. Perform all
assembly steps on a flat, soft, non-abrasive surface. Do not over-tighten the screws or bolts.
Page 1
Assembly Instructions Crystal Bay Dining Table Model # 5000048-0106102
! KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE !
For question, please contact Thomasville Outdoor toll-free at 1-866-606-6341 or [e-mail]
Parts and Hardware List

1. Connect the table legs (B) to the base support (G) by using: plain washer (C), spring washer (D), 1
3/8” screw (E), hex wrench (F). Do NOT tighten the screws until all eight have been inserted. Once
all eight screws have been inserted, securely tighten each of the screws using the hex wrench (F).
After all eight screws have been securely tightened, install the screw covers (I). See Figure I.
Note: Make sure the drain hole in the base support (G) is facing downward.
Page 2
Assembly Instructions Crystal Bay Dining Table Model # 5000048-0106102
! KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE !
For question, please contact Thomasville Outdoor toll-free at 1-866-606-6341 or [e-mail]
2. Place the table frame (A) upside down on a flat, soft, non-abrasive surface. Connect the base
support (G) / table legs (B) to the table frame (A) by using: plain washer (C), spring washer (D),
3/4” screw (H), hex wrench (F). Do NOT tighten the screws until all four have been inserted. Once
all four screws have been inserted, securely tighten each of the screws using the hex wrench (F).
After all four screws have been securely tightened, install the screw covers (I). See Figure 2.
Figure 1
Figure 2
3. Turn the table 180˚. Insert glass (J) into table frame (A). Place the umbrella hole protector (K) in the glass
(J). Insert the umbrella hole cover (L) into the umbrella hole protector (K). See Figure 3.
Figure 3