NBB Oakfield Bench User manual

Oakfield Bench with back Oakfield Bench without back
Li s t Li s t
Necessary Tools
Tape or folding rule
Spiral drill ø= 6 mm and drilling machine
Bar clamps, scissors
NBB
Unit5, Sterte Road Industrial Estate, Sterte Road
Poole, Dorset
BH15 2AF
Tel: [phone] Email: [email protected].uk Web: www.nbbschoolshelters.co.uk
No.
Drawing
Benchfeet
2
Seatelement
1
Back element
Screw
14
Bit
1
No.
Drawing
Benchfeet
2
Seatelement
1
Screw
14
Bit
1
Oakfield Bench
Parts Li s t
Parts Li s t
Necessary Tools (both types)

Schritt 1Schritt 1
Schritt 1Schritt 1
Schritt 1Schritt 1
Schritt 1Schritt 1Schritt 1
Oakfield Bench with back Oakfield Bench without back
Step 1 Step 1
Fix the seat element with the upper side down on
a clean and solid work place.
Fix the seat element with the upper side down on a
clean and solid work place.
Step 2 Step 2
Adjust the bench foot centered at the installation
support and drill through the given holes of the foot
with a 6mm spiral drill (7 holes per foot). Fix the foot
(7 screws per foot) to the seat element.
Adjust the bench foot centered at the installation
support and drill through the given holes of the foot
with a 6mm spiral drill (7 holes per foot). Fix the foot
(7 screws per foot) to the seat element.
Step 3 Step 3
Place the bench with the feet on the floor (attention:
may tip over) and install the back element according
step 2 (6 screws per side). Secure the element during
assembly with bar clamps.
Step 4
After assembly the installation support can be removed.
Therefor carefully cut the green tape (tension!).
Take care to find a safe and stable place for the bench.
After assembly the installation support can be removed.
Therefor carefully cut the green tape (tension!).
Take care to find a safe and stable place for the bench.
NBB
Unit5, Sterte Road Industrial Estate, Sterte Road
Poole, Dorset
BH15 2AF
Tel: [phone] Email: [email protected].uk Web: www.nbbschoolshelters.co.uk