Thor Fiber F-RSD Series User manual

Quick installation Guide
Thor Fiber F-RSD-XX RS-
232/485/422 Over Fiber
Thank you for purchasing the Thor fiber optic
This product is a multi-
purpose asynchronous fiber optic device that can extend
RS-
232/485/422 serial control over a single fiber optic line. This greatly increases
the efficiency in transmission function while simultaneously protecting transmission integrity
from common issues such as weather, surge, or electromagnetic interference.
Quick start guide:
There are two devices in this package
found on the bottom label of the devices under “Product Type:”
Each device will also include a 5v dc power adapter (please only use the
adapters as any higher vo
ltages may result in damage to the unit).
1) Connect power adapter to device "A", and repeat the process for device "B".
Status lights:
Each unit has 2 status indicator LEDs that are labeled PWR and FIBER.
When sufficient
power is supplied to each device the PWR indicator LED
will light up with a solid green.
INSERT POWER
232/485/422 Over Fiber
Thank you for purchasing the Thor fiber optic
Transmitter / receiver system.
purpose asynchronous fiber optic device that can extend
232/485/422 serial control over a single fiber optic line. This greatly increases
the efficiency in transmission function while simultaneously protecting transmission integrity
from common issues such as weather, surge, or electromagnetic interference.
There are two devices in this package
labeled either "A", or "
B"(The A or B designation can be
found on the bottom label of the devices under “Product Type:”
F-RSD-
A
-TX/RX | F-
RSD
Each device will also include a 5v dc power adapter (please only use the
manufacturer’s
ltages may result in damage to the unit).
1) Connect power adapter to device "A", and repeat the process for device "B".
back view of the unit
Each unit has 2 status indicator LEDs that are labeled PWR and FIBER.
power is supplied to each device the PWR indicator LED
Front view of the unit
the efficiency in transmission function while simultaneously protecting transmission integrity
B"(The A or B designation can be
RSD
-
B-
TX/RX
).
manufacturer’s
supplied

Before the fiber port on either device is connected the FIBER
status indicator light will blink on and off. This is indicating that
the device is ready and it is waiting for communication with the other
Install one side of a standard (Fiber cable) into the fiber port on device "A"
and the other into the f
iber port on device "B".
Once the devices have established a link the FIBER status indicator LEDs on both
devices will turn off. The following image that shows the correct LED status for a n
successful fiber connection.
Unit A
Before the fiber port on either device is connected the FIBER
status indicator light will blink on and off. This is indicating that
the device is ready and it is waiting for communication with the other
device.
Install one side of a standard (Fiber cable) into the fiber port on device "A"
iber port on device "B".
Once the devices have established a link the FIBER status indicator LEDs on both
devices will turn off. The following image that shows the correct LED status for a n
Unit B
devices will turn off. The following image that shows the correct LED status for a n