Thor’s Drone World Lifthor Baldur 2 User manual

by Thor’s Drone World
User’s Manual

Congratulations on your new
The New & Improved Tablet holder
for DJI Mavic AIR 2(s) / Mini 2 / Mavic 3 PRO

Aluminum base
Content:
:
Universal clamp
Compatible with smart phones
and up to 12.9” tablets
(expanding clip range
65mm - 230mm)
Hex Key /Allen Key
Star knob
thumbscrew
(¼” -20 x ½ ”)

How to assemble:
Remove the wing knob
thumbscrew located on the
back of the aluminum base

*Note:
The aluminum base has pre-installed anti-slip pad to protect the RC
from any scratches and keep it secure in place.
Wing knob
thumbscrew
(M5 x 20mm)
Main aluminum base
Neck
Utility mount

Prepare the RC by extracting the antenna all the way out

Gently lower the RC into the bay of the base with a slight
inclination. Aligning the RC center to the mount

Make sure the RC is aligned and centered properly

Reconnect the neck of the aluminum base between
the antenna bars back to the main body.

Finish screwing back the wing
knob thumbscrew in place
The RC is now securely mounted to the
LifThor Baldur2 holder

Insert the star knob thumbscrew from below the utility mount
through the small round hole.

If needed you can loosen up the utility mount using the hex key
provided to adjust its angle.

Screw the universal clamp in place

The NEW universal
clamp has two
mechanisms to ensure
your tablet sit secure
and in place.
The first mechanism is
the ratchet part, it can
be extended in 6 fixed
steps (3 on the top / 3
on the bottom) to adjust
to the size of your
tablet. We recommend
setting it a little smaller
(1” / 2.5cm) than the
actual size of the tablet
for a tight, secure fit.
Press and hold
the side buttons to
extend the ratchet
mechanism
Ratchet part to→
adjust the height
Release→
button
Release
button

Spring
mechanism
Place the phone / tablet in landscape mode by pulling the spring
mechanism upwards and release it to secure the device in place.
* It’s the spring-loaded part that will hold your device in place !

Compatible with most smart phones and tablets up to 12.9”
Minimum expanding 6.5cm –Maximum expanding 23 cm

Alternative setups:
Integrated tripod
mounting point located
underneath the
aluminum base

*StrapThor Pro –Body Tripod sold separately

*StrapThor Pro Lanyard sold separately / or included in combo kit