Thor’s Drone World LIFTHOR MJOLNIR EVO User manual

by Thor’s Drone World
User’s Manual

Congratulations
on your new
the Ultimate Tablet holder
for Autel EVO 1 & 2

Aluminum body
Content:
Aluminum
ball joint
Tablet clamp
Compatible with 7.9” up to
13” devices
Support plate
Hex Key (x2)
Thumb
Screws (x2)

How to assemble:
Remove the components from the box, use the bigger hex
key provided to unscrew the ball joint from the box inlay.
Using the bigger Hex key
provided, secure the ball joint
on the top hole of the
aluminum body.
Make sure it is tightened well.

With the smaller hex key
provided, unscrew the
aluminum stopper from
the underside of the body.

Remove the stopper
completely from the
main body.
*Note:
The body has 2 anti-slip pads to
protect the RC from any scratches
and keep it secure in place.
Stopper

Attach the stopper to the RC with
one of the thumb screws provided.

Gently lower the RC into the bay of the base with a slight
inclination.
PRO TIP: Open the cover for the
cable input slightly before
installing the RC.

Make sure the RC is centered and aligned properly

Once everything is in place, secure the
stopper from underneath the body,
with the small Hex Key provided.

Unscrew the tightening ring from the back of the
Tablet Clamp and place it on the ball joint
tightening
ring 

Attach the clamp to the
ball joint and screw the
ring back to secure the
clamp position / angle.
tightening ring 

The clamp has two
mechanisms to ensure
your tablet sit secure and
in place.
The first mechanism is the
ratchet part, to adjust to
the size of your tablet. We
recommend setting it a
little smaller (1” / 2.5cm)
than the actual size of the
table for a tighter, secure
fit.
Once you have
selected the right height
lock the ratchet in place
by sliding the lock
downwards.

Ratchet part
to adjust the
height
Lock



Spring mechanism
Place the tablet in landscape mode by pulling the spring
mechanism upwards and release it to secure the tablet in place.
You can adjust the top clamp brackets, if needed, to avoid
pressing on any buttons
*Scan the QR code
with your phone for a
video tutorial

Compatible with most small tablets like iPad Mini or similar up to
larger tablets like the iPad Pro 12.9” and everything in between

Alternative setup
without support plate
with support plate

Installation of support plate
Start by connecting the
cable to the RC
Thread the cable through
the top of the hole from
the support plate
Secure the support plate to
the main body with the
thumb screw provided

Integrated tripod
mounting point
located underneath
the main body

Separately sold
accessories:
Exchangeable
phone clamp
Mounting bracket
for 4Hawks antenna
Mounting bracket
for CrystalSky
Monitor

www.lifthor.com