Thorne & Derrick Roxtec CRL 4" User manual

Installation Instructions
Roxtec CRL 4" and 5"
Installation
Insert the frame into the sleeve
opening.
Lubricate the frame sparsely on
the outside black rubber part with
Roxtec Assembly Gel.
Lubricate the inside faces of the
frame thoroughly, especially into
the corners.
Lubricate all modules for the frame
thoroughly, both the inside and the
outside surfaces.
Achieve a 0.1-1.0 mm gap between
the two halves when held against
the cable/pipe.
Adapt modules which are to hold
cables or pipes by peeling off
layers until you reach the gap seen
in pic. 5b.
Insert the modules in the frame.
Push the front fittings back towards
the centre.
Tighten the nuts.
Max torque is 4 Nm/2.95 lbf·ft.
Loosen the nuts and push the front
fittings to the sides.
The installation is complete.Excess Roxtec Lubricant will
protrude when tightening the seal.
Approx. 8 mm/0.315"

Roxtec ® and Multidiameter ® are registered trademarks of Roxtec in Sweden and/or other countries.
ASS2009001801 ver_1.2/GB/1001/kasve
Pcs Module (mm) For cable diameter (in)
1 CM 66 0+24-54 0+0.945-2.126
Pcs Module (mm) For cable diameter (in)
2 CM 33w66 2x0+10-29 2x0+0.394-1.142
Pcs Module (mm) For cable diameter (in)
3 CM 22w66 3x0+5-16.5 3x0+0.197-0.650
Pcs Module (mm) For cable diameter (in)
1 CM 22w66 3x0+5-16.5 3x0+0.197-0.650
1 CM 11/0
1 CM 33w66 2x0+10-29 2x0+0.394-1.142
Disassembly
Reverse order
For optimum reliability, wait 24 hours or longer after installation before exposing the cables/pipes to strain or pressure.
Cables/pipes shall be routed perpendicularly to the wall.
Note
Roxtec CRL kits
 All kits include Roxtec Assembly Gel and installation instructions.
Roxtec CRL 4"/1 Roxtec CRL 5"/1
For 1 cable
Roxtec CRL 4"/4 Roxtec CRL 5"/4
For 4 cables
Roxtec CRL 4"/5 Roxtec CRL 5"/5
For 5 cables
Roxtec CRL 4"/9 Roxtec CRL 5"/9
For 9 cables