Thrive Energy Technologies ACCENDO Installation guide

# FAQ Solution Procedure
1
The lamp is OFF and unable
to switch ON
a. Press the ON/OFF push button and check lighting level in all the three
lighting modes.
b. Check the Low battery indication. f the battery indication is showing Red
with a Continous blink, the light needs to be charged immediately with the
Solar panel or mains charger.
2
The lamp is not charging
although the solar panel is
connected to the light
a
.
Check the direction, angle of installation and cable of solar panel to ensure
perfect charging of the ACCENDO lamp. Please refer to user manual for the
solar panel installation instructions.
b. Observe the charging indication on the ACCENDO lamp. The lamp should
show RED while charging the battery and GREEN after full charge.
c. Measure the internal battery voltage using a multimeter. f the battery is
Charged the voltage should be 6.4V (DC) and when the battery is discharged
the voltage should not be less than 5.4V (DC).
3
What needs to be done
when the ACCENDO has a
less back up or runtime?
When the light lasts for
few hours?
a
.
The back up or run time is also reduced if the battery is not properly charged
using a charging source.
b. f the back up or runtime is low it means that the battery lifetime is about to
expire. Please change the battery with the new one.
FAQs on Maintenance and Repairs of ACCENDO Solar ED Home ight

4
Do we get replacement
spare parts for the
ACCENDO Solar LED Home
Light?
The replacement spare parts are available with any of THR VE® ENERGY partners,
resellers, local dealers and distributors.
ist of spare parts:
1. Electronic circuitry
2. Rechargeable SMF battery 6V/4.5Ah
3. LED module
4. other parts like cables, switches etc.
5
Whom do we contact in
case of technical or local
support apart from the
local reseller, distributor or
partner?
Customers are requested to contact on [e-mail];
[e-mail] or visit our website for more assistance:
www.thriveenergy.co.in
6
The lamp is exposed to
Continous rain and is not
lighting even after charging
the light with Solar panel.
a. Do not charge the light immediately when the light is wet.
b. f the light is not functioning, replace the internal electronic circuit or any defective
component with the new one.