Timex 75322A1 User manual

In the event you wish to manually change the clock settings, please use the
instructions on the following page.
3) Choose Your Time Zone – You must set your time zone so the clock will display
accurate time once the atomic signal is received:
a. Select your time zone by repeatedly pressing the () ARROW until you
see your time zone displayed on the LCD screen.
1) Battery Installation – remove the battery compartment cover on the back of the
unit and install 2 FRESH “AA” batteries as shown here.
2) Initial Setup – once the batteries are installed, the clock will power up.
The display will appear as follows:
The clock will begin searching for the Atomic signal
If the signal is AVAILABLE– the clock will receive the local time in 3-5 minutes.
The full strength signal indicator bars will appear on the display.
If the signal is NOT readily available – you can manually set the clock and calendar
(SEE MANUAL SETTING INSTRUCTIONS)
After the clock acquires the Atomic clock radio signal (this may take 24-48 hours)
the time, date and daylight saving time changes will update automatically, giving you
maintenance-free operation and perfect time precision.
-2-
BASIC SETUP
Time Zone will
default to PST
(Pacific Standard Time)
Signal Indicator
will be flashing
Room Temp indicator
will be flashing
-3-
SETTING THE CLOCK MANUALLY
Manual Button
Functions
PST
Pacific Standard
Time
MST
Mountain Standard
Time
CST
Central Standard
Time
EST
Eastern Standard
Time
HAST
Hawaii Aleutian
Standard Time
AKST
Alaska Standard
Time
AST
Atlantic Standard
Time
1) SETTING THE CLOCK & CALENDAR
a) Press the “SET” button for several seconds until the LCD
screen is flashing.
b) Press the UP () ARROW button to select 12 Hr. (standard) or
24 HR. (Military) time format. Press “SET” to confirm.
Press the UP () ARROW repeatedly,
until the correct hour (AM or PM) is
displayed.
Press the UP () ARROW repeatedly,
until the correct minute is displayed.
Press the UP () ARROW repeatedly,
until the correct year is displayed.
Press the UP () ARROW repeatedly,
until the correct month is displayed.
Press the UP () ARROW repeatedly,
until the correct date is displayed.
Set the Atomic Clock ON or OFF by
pressing the UP () ARROW button.
Press “SET”
to confirm.
Press “SET”
to confirm.
Press “SET”
to confirm.
Press “SET”
to confirm.
Press “SET”
to confirm.
Press “SET”
to confirm.
c) The HOUR will flash
d) The MINUTE will flash
e) The YEAR will flash
f) The MONTH will flash
g) The DATE will flash
h) The ATOMIC CLOCK
CONTROL will flash
Set DST (Daylight Saving Time)
ON or OFF by pressing the UP ()
ARROW button.
Press “SET”
to confirm.
i) The DST will flash
Select F˚/C˚ (Fahrenheit or Celcius) by
pressing the UP () ARROW button.
Press “SET”
to confirm.
j) The F˚/C˚ will flash
SET
Back of Clock
Up/Down
Arrows
“Set” to confirm
manual settings
TIME ZONE
SET
TIME
ZONE