Tippkemper CNS-506 User manual

Capacitance Level Sensor
CNS-506
Level control for:
•waxes
•granulates
•paints
•hot-melt adhesives
•chemicals
Type
Technical data
CNS-506
Nominal voltage 15-30V/DC
Nominal current 30 mA
Switching frequency ≤0.5 Hz
Output voltage max. 100V AC/DC
Output current max. 0.5A
Connecting cables 4 X 0,25 mm² + screen / L = 2 m
Pin arrangement
BN - brown
GN - green
YE - yellow
WH - white
screen and housing - ground
BN
GN
YE
WH
L-
L+
SCREEN
Housing material Aluminium
Permissable ambient temperature +10°C to +50°C
Type of protection IP 65 / EN 40050
Output
LED-display red LED on green LED on
C
NO
C
NO

CNS-506_E.DOC 08/01
Dimensions:
113 mm
101 mm
89 mm
5 mm
13 mm
5 mm
36 mm
LED's Poti t = 30 mm
Operating Manual
Mounting Instructions
The pin configuration is to be strictly observed.
The appliance is only to be operated with the
voltage entered on the rating plate. The glue
receptacle and the screening of the connection
lines are to be safety grounded. The probe- and
connection lines are not to be laid parallel to the
drive connections. The amplifier is not to be
installed onmachine components which are hot
and subjected to strong temperature
fluctuations. The probe distance to the vessel
wall must amount at least 30mm. The influence
of strong suction effect by cooling glue, can
conduct to material fatigue and in extreme
cases to probe destruction.
Function
The capacitive level sensor is provided for the
detection of insulant, solid and non-conducting
substances. The appliance evaluates the
capacity modifications ∆C of the probe base
capacity.
Adjustment/Operation
The adjustment of the appliance is simply to be
seen as a tolerance compensation. Resulting
from installation, filling media and the
fabrication, tolerances are given, which are so
compensated. The adjustment occurs, with the
potentiometer (level), over the probe sensitivity,
and must always be made with the effectively
used filling media. In direction of rotation to the
right, the level increases. In direction of rotation
to the left, the level decreases. In the case of a
possible defect of the appliance, the exit can
take any condition on.
Maintenance
The appliance is maintenance free. Appliances
are only to be repaired or touched up by the
manufacturer.
General
With installation and operation of the capacitive
level sensor, CNS 506, the EU- and national
regulations must be considered. Our appliances
are on a high technical level. Modifications,
which serve the technical progress, are
reserved.
Met standards
EN 50081-1; EN 50081-2
EN 50082-1; EN 50082-2
EU-directives
89/336/EWG; 92/31/EWG; 93/68/EWG
Tippkemper Elektronik GmbH & Co KG
Zum Kreuzweg 12, D-59302 Oelde, Germany, Tel. [phone] / 93 01-50, Fax. [phone] / 93 01-49