TMB ProPlex GBS User manual

ProPlex GBS 5-Port Ethernet Switch
Quick Start Guide
TMB 24/7 Technical Support
US/Canada: +1 818.794.1286
Toll Free: 1 877.862.3833 (877.TMB.DUDE)
UK: +44 (0)20.8574.9739
Toll Free: 0800.652.5418 v.1.0 rev 070819
e-mail: tec[email protected]

Introduction
The ProPlex GBS 5-Port Ethernet Switch is an unmanaged switch with four 10/100 Mbps
ports and one 1Gbps port. The 10/100Mbps ports include PoE functionality (IEEE 802.3af
compliant). Suitable for multicast, video, audio, or lighting, just a few key features include:
•One Gigabit port, four 100 Mbps PoE ports
•Overall 60W PoE power budget, 15W per output, 48 VDC
•Compatible with a wide range of entertainment-specific protocols, including sACN,
ArtNet, CobraNet, ETCNet, Ethersound, and MA-Net
•Powerful and compact, for network applications of all kinds
•Complete range of DIN Rail Devices and Drives to make a complete system!
Technical Data
Part number
PPGBSPOEDIN005
Output channels
5
Operating voltage
48 VDC
Output Power
60 W max.
Power input
Phoenix MSTB 2-terminal
Ethernet Ports
RJ-45
Speed rates
4x 10-100 Mbps PoE
1x 1 Gbps
PoE support
YES (IEEE 802.3af compliant)
Dimensions (HxWxD)
1.8 x 4.1 x 3.63 in (45,7 x 104 x 92,30 mm)
Weight
0.35 lbs (159 g)

Dimensions
Dimensions in inches (mm)

Overview
Setup
ProPlex DIN Rail devices use a standard Phoenix MSTB screw terminal connector in various
pin configurations. Please refer to the wiring diagrams below for correct hook up of your
ProPlex DIN Rail product.
1. Connect the 48 VDC power to the power input located in top left corner. The
connector should be wired as depicted in the image below.
2. To use the PoE function:
a. Connect the Ethernet cable with the RJ45 connector to Ethernet ports 1-4
located at the bottom of the unit.
b. When using PoE to pass electric power and data, the switch can provide
up to 15.4 W per output (IEEE 802.3af compliant).
c. Important: The 1 Gbps ethernet port at the top right of the unit does not
support PoE.

LED status information
The Power LED has two states: ON and OFF.
• ON: Unit is receiving power
• OFF: Unit is not receiving power
Link LED has 2 statuses: ON and OFF
If the LED is lit, then the link is connected.
If the LED is off, then the link is not connected.
Activity LEDs has 2 statuses: blinking and OFF
If the activity LED is blinking, link is active and receiving data.
If the activity LED is OFF, the link is not active.