Toa ST-310F User manual

1. SAFETY PRECAUTIONS
• Be sure to read the instructions in this section carefully
before use.
• Make sure to observe the instructions in this manual as
the conventions of safety symbols and messages
regarded as very important precautions are included.
• We also recommend you keep this instruction manual
handy for future reference.
Safety Symbol and Message Conventions
Safety symbols and messages described below are used
in this manual to prevent bodily injury and property
damage which could result from mishandling. Before
operating your product, read this manual first so you are
thoroughly aware of the potential safety hazards as well as
understand the safety symbols and messages.
When Installing the Unit
• Avoid installing or mounting the unit in unstable
locations, such as on a rickety table or a slanted surface.
Doing so may result in the unit falling down and causing
personal injury and/or property damage.
When Installing the Unit
• Avoid placing the unit in a doorway or other high traffic
area as people may trip on the equipment and cords, or
be injured by falling objects.
When the Unit is in Use
• Do not place a heavy object on the stand, because the
object may fall off or the stand fall down, potentially
causing a personal injury. The maximum weight of the
microphone that can be mounted to the stand is 2 kg.
2. HANDLING PRECAUTIONS
• Do not get hold of the upper shaft when moving the
stand. The stand may become distorted and its height
cannot be adjusted smoothly. Hold the lower shaft to
move the stand.
• Do not try to rotate the grip because it is designed not to
rotate. The upper shaft cannot be fixed if the grip is
rotated by force.
ST-310FMICROPHONE STAND
INSTRUCTION MANUAL
Indicates a potentially hazardous situation which,
if mishandled, could result in death or serious
personal injury.
Indicates a potentially hazardous situation which,
if mishandled, could result in moderate or minor
personal injury, and/or property damage.
WARNING
CAUTION
WARNING
CAUTION
Thank you for purchasing TOA's Microphone Stand.
Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
Thread adapter
Lock nut
Stand thread
Grip
Upper shaft
Lower shaft
Projection
(rotation stopper)
Cable clip
(2 pieces)
Base
T-bolt with washer
3. NOMENCLATURE

Base Diameter ø360 mm
Shaft Diameter Upper shaft: ø15.9 mm
Lower shaft: ø22.2 mm
Stand Thread W3/8
Thread Adapter U5/16
Adjustable Stand Height 908 – 1,515 mm
Weight 3.8 kg
Finish Shaft: Chrome plating
Base: Semi-mat paint, black
Specifications are subject to change without notice.
7. SPECIFICATIONS
URL: http://www.toa.jp/
4. ASSEMBLY
Step 1. Aligning the lower shaft's projection with the
corresponding hole in the base, insert the lower
shaft into the base. Then, tighten T-bolt from the
back of the base.
Step 2. Turn the lock nut to mount it to the stand thread,
then mount the optional microphone holder to the
thread. (When there is a gap between the holder
and lock nut, loosen the lock nut till the gap has
been covered. This permits the holder to be fixed
tightly.)
* Use the thread adapter
when the microphone
holder cannot be
mounted to the stand
thread.
Step 3. Run the microphone cable through the cable clip,
then mount the clip to the lower shaft.
Thread adapter *
Lock nut
Stand thread
Upper shaft
Cable clip
Lower shaft
Microphonecable
Cableclip
Squeeze both tabs till
the clip clicks to be
locked.
To detach the cable clip, twist
tabs in the direction marked with
the arrows using fingers.
Lower shaft
Base
(Projection) hole
Projection
(rotation stopper)
T-bolt (with washer)
5. HEIGHT ADJUSTMENT
The height can be adjusted by simply raising
or lowering the upper shaft.
6. COMPLETED ASSEMBLY FIGURE