TOPSCCC EX-300-96122 User manual

EX-300-96122
USER'SMANUAL
MEASUREMENT
Box PC
198x126x72 mm
CPU TYPE
FC-BGA
CHIPSET
INTEL
82815E
LAN
10/100
BASE-T
MEMORY
SODIMM
512MB
IDE
UltraDMA-33
AUDIO
AC'97
I/O
USB/Serial/
LPT/CF I & II/
Mini PCI
CPU
ULV
Celeron
400MHz

2
EX-300-96122 User's Manual
Copyright©2004
All Rights Reserved.
The information in this document is subject to change without prior notice in order to
improve the reliability, design and function. It does not represent a commitment on the
part of the manufacturer.
Under no circumstances will the manufacturer be liable for any direct, indirect, special,
incidental, or consequen-tial damages arising from the use or inability to use the product
or documentation, even if advised of the possibility of such damages.
This document contains proprietary information protected by copyright. All rights are
reserved. No part of this manual may be reproduced by any mechanical, electronic, or
other means in any form without prior written permission of the manufacturer.
FCC Class A
This equipment has been tested and found to comply with limits for a Class A digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference installations. This equipment generates,
uses and can radiate radio frequency energy, and if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to radio or television equipment reception,
which can be determi ned by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures: -Reorient or
relocate the receiving antenna
-Move the equipment away from the receiver
-Plug the equipment into an outlet on a circuit different from that to which the receiver is
connected
-Consult the dealer or an experienced radio/television technician for additional suggestions
You are cautioned that any change or modifications to the equipment not expressly
approve by the party responsible for compliance could void Your authority to operate such
equipment.
Important Safety Instructions
1Read these safety instructions carefully.
2Keep this User's Manual for later reference.
3Disconnect this equipment from any AC outlet before cleaning. Use a damp cloth.
Do not use liquid or spray detergents for cleaning.
4. For plug-in equipment, the power outlet socket must be located near the
equipment and must be easily accessible.
5Keep this equipment away from humidity.
6Put this equipment on a reliable surface during installation. Dropping it or letting it
fall may cause damage.
7The openings on the enclosure are for air convection. Protect the equipment from
overheating. DO NOT COVER THE OPENINGS.
8Make sure the voltage of the power source is correct before connecting the
equipment to the power outlet.
9Position the power cord so that people cannot step on it. Do not place anything
over the power cord.
10 All cautions and warnings on the equipment should be noted.
11 If the equipment is not used for a long time, disconnect it from the power source
to avoid damage by transient overvoltage.
12 Never pour any liquid into an opening. This may cause fire or electrical shock.
13 Never open the equipment. For safety reasons, the equipment should be opened
only by qualified service personnel.
14 If one of the following situations arises, get the equipment checked by service
personnel:
a. The power cord or plug is damaged.

3
EX-300-96122 User's Manual
b. Liquid has penetrated into the equipment.
c. The equipment has been exposed to moisture.
d. The equipment does not work well, or you cannot get it to work according to
the user's manual.
e. The equipment has been dropped and damaged.
f. The equipment has obvious signs of breakage.
DO NOT LEAVE THIS EQUIPMENT IN AN UNCONTROLLED ENVIRON-MENT WHERE
THE STORAGE TEMPERATURE IS BELOW -20°C (-4°F) OR ABOVE 60°C
(140°F). THIS MAY DAMAGE THE EQUIPMENT.
The sound pressure level at the operator's position according to IEC 704-1:1982 is no
more than 70dB(A).
About this User's Manual
This User's Manual provides general information and installation instructions about the
Box PC. This User's Manual is intended for experienced users and integrators with
hardware knowledge of personal computers. If you are not sure about any description in
this User's Manual, please consult your vendor before further handling.
Ordering Information
EX-300-96122
EXPERT with EX-9i612VL
PAD-HPA-50A42U3
Table of Contents
Introduction ................................................................................... 4
Getting Started .............................................................................. 4
Dimension ......................................................................................................... 5
Overview ........................................................................................................... 6
Hardware Installation ................................................................... 7
Installing Mini PCI ............................................................................................. 8
Installing Hard Disk Drive .................................................................................. 9
Installing Memory Module ............................................................................... 10
Installing Wall-Mount Bracket .......................................................................... 11
Box PC Kernel Information ........................................................ 12
System Resources ...................................................................... 12
AWARD BIOS Setup .................................................................... 14
Setup Items ..................................................................................................... 14
Standard CMOS Setup .................................................................................... 15
BIOS Features Setup ...................................................................................... 16
Chipset Features Setup ................................................................................... 18
Integrated Peripherals ..................................................................................... 19
Power Management Setup .............................................................................. 21
PNP/PCI Configuration ................................................................................... 22
PC Health Status ............................................................................................ 22
Frequency/Voltage Control .............................................................................. 23
POST Codes ................................................................................ 23
Howto : Flash the BIOS .............................................................. 28
Warranty ....................................................................................... 28

4
EX-300-96122 User's Manual
Getting Started
This section will help you have your EX-300-96120 up and running smoothly. For further
information, please refer to EX-9i612 Quick Installation Guide.
Introduction
Box PC is targeted at many different application fields. By adopting Box PC, you can
pinpoint specific markets, such as Thin Client, KIOSK, information booth, GSM Server,
environment-critical and space-critical applications.
Box PC is specially designed for 3.5" and 5.25" Miniboards. The modular design of the
Box PC is prepared for any OEM projects. Modular Box PC can be easily modified to fit
many different applications according to customers' requests.
Compact-sized
The kernel of EX-300-96122 is EX-9i612, which is a 3.5" drive size embeded board.
The whole system consumes only a few space.
CRT SVGA
EX-300-96122 can support super 2D video performance and consumes minimal power.
Advanced storage solution
EX-300-96122 comes with Compact Flash & Mini PCI slots, which offer a better, faster
and more cost-effective expansibilities for various applications.
Trustworthy
The onboard Watchdog Timer can invoke an NMI or system RESET when your application
loses control over the system.
Before up and running, please make sure the package contains all of above accessories.
If any of the above items is damaged or missing, contact your vendor immediately.
EX-300-96122
PACKING LIST
IDE Cable w/SR
PAD-HPA-501242U3
Power Cord
1 x CD-ROM (driver)
EX-9i612VL Quick Installation
Server

5
EX-300-96122 User's Manual
Dimension
8.00
4.00
4.00
Unit : mm
Table of contents
Other TOPSCCC Industrial PC manuals
Popular Industrial PC manuals by other brands

Dell
Dell Embedded Box PC 5000 Installation and operation manual

IBASE Technology
IBASE Technology ASB200-918 Series user manual

Lenovo
Lenovo ThinkCentre M90q Hardware Maintenance Manual

IXXAT
IXXAT Econ 100 Hardware manual

Kontron
Kontron KBox A-151-TGL user guide

AXIOMTEK
AXIOMTEK ICO500-518 Series user manual