Toro GrandStand 147-0305 User manual

Form No. 3463-166 Rev A
T rash Bag Kit
GrandStand
®
Revolution Mower
Model No. 147-0305
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description
Qty .
Use
1
No parts required
–
Prepare the machine.
Bag bracket 1
Storage-bag rod
1
Storage bag
12
Screw (5/16 inch)
2
Install the kit.
3
No parts required
–
Complete the installation.
© 2023—The T oro® Company
81 1 1 L yndale A venue South
Bloomington, MN 55420 Register at www .T oro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3463-166*

1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Disengage the drives and the power take-of f.
3. Shut of f the machine and remove the key .
4. W ait for all moving parts to stop.
5. T urn the battery-disconnect switch to the O FF
position.
6. Lower the platform.
7. Loosen the twist knobs on each side of the
machine.
g375719
Figure 1
1. T wist knob
2. Cushion
8. Lower the cushion to the platform.
9. Remove the rear access cover .
g441 1 12
Figure 2
2
Installing the Kit
Parts needed for this procedure:
1 Bag bracket
1
Storage-bag rod
1
Storage bag
2
Screw (5/16 inch)
Procedure
1. On the left side of the machine, measure and
mark the 2 holes as shown below .
g443574
Figure 3
1. 12.34 cm (4.86 inches) 3. 15.88 cm (6.25 inches)
2. 17.25 cm (6.79 inches) 4. 14.5 cm (5.71 inches)
W ARNING
Using a drill without proper eye
protection may allow debris to enter the
eye, causing injury .
When drilling, always wear eye
protection.
2. Use a drill bit (9/32 inch) to drill through the 2
marked hole locations.
Note: When drilling, avoid pushing the drill bit
too far beyond the plate.
3. Use compressed air to remove the metal
shavings from drilling.
2

4. Install the bag bracket to the tower plate using 2
screws (5/8 inch).
g441095
Figure 4
1. Bag bracket
2. Screw (5/8 inch)
5. Slide the storage-bag rod into the storage bag.
g441 1 10
Figure 5
1. Storage-bag rod 2. Storage bag
6. Install the storage bag assembly onto the bag
bracket.
Note: If the T rimmer Kit is installed on the
machine, the rear hole of the T rash Bag Kit and
the lower hole of the T rimmer Kit mount bracket
share the same hole when assembled together .
g441 1 1 1
Figure 6
3
Completing the Installation
No Parts Required
Procedure
1. Install the rear access cover .
g441 1 12
Figure 7
2. Raise the cushion to the platform.
3. T ighten the twist knobs on each side of the
machine.
g375719
Figure 8
1. T wist knob
2. Cushion
4. T urn the battery disconnect switch to the O N
position.
3