Toshiba TDP-S2 User manual

i
TABLE OF CONTENTS
Safety Instructions iii
Introduction 1
Image Resolution 1
Compatibility 2
Unpacking the Projector 2
Usage Guidelines 4
If You Need Assistance 5
Setting up the Projector 7
Connecting a Computer 9
Connecting a Video Player 11
Powering up the Projector and Adjusting the Image 13
Turning Off the Projector 14
Using the Projector 15
Basic Image Adjustment 15
Using the Remote Control 15
Adjusting the Projector 17
Using the Keypad and Remote Buttons 18
Using the On-Screen Menus 20
Display Menu 21
Audio Menu 23
Image Menu 24
Controls Menu 27
Language Menu 29
Status Menu 30
Maintenance & Troubleshooting 33
Cleaning the Lens 33
Replacing the Projection Lamp 33
Replacing the Batteries in the Remote Control 36
Using the Security Lock 36
Troubleshooting 37

ii
T a b l e o f C o n t e n t s
Appendix 41
Specifications 41
Accessories 42
Portable and Laptop Activation Chart 43
Using Video Mirroring with a PowerBook Computer 48
Projected Image Size 49
Index 51

iii
SAFETY INSTRUCTIONS
Please read and follow all safety instructions provided BEFORE
using your new projector. Failure to comply with safety instruc-
tions may result in fire, electrical shock, or personal injury and
may damage or impair protection provided by equipment. Please
save all safety instructions.
Safety Definitions:
•Warning: Statements identify conditions or practices that
could result in personal injury.
•Caution: Statements identify conditions or practices that could
result in damage to your equipment.
Safety Symbols:
Attention: For information about usage of a feature, please
refer to the User’s Guide.
Warning: Hot surface. Do not touch.
An arrow pointing to the lamp door on the projector.
Safety Terms:
•Warning: Don’t look directly into the lens when the lamp is
turned on.
•Warning: To replace the lamp, turn the projector off by
unplugging the power cord. To avoid burns, wait 30
minutes before opening the lamp door. Follow all instructions
provided in this User’s Guide.
•Warning: Please use the power cord provided. Connect
the power cord to a receptacle with a protective safety
(earth) ground terminal.
•Warning: Refer all service to qualified service personnel. Ser-
vicing your own projector will void the warranty. See the fol-
lowing page for the customer service contact information.
•Caution: Don’t block ventilation openings.

iv
S a f e t y I n s t r u c t i o n s
•Caution: Don’t set liquids on the projector. Spilled liquids may
damage your projector.
•Caution: Don’t place the projector on a hot surface or in direct
sunlight.
•Caution: Do not drop the projector. Transport the projector in a
vendor-approved case; refer to your Toshiba dealer or
projectors.toshiba.com for more information.
Important Operating Considerations
Do not place the projector on a tablecloth or other soft covering
that may block the vents. In the unlikely event of the bulb ruptur-
ing, thoroughly clean the area behind the projector and discard
any edible items placed in that area.
Customer Service
Please contact your Toshiba dealer for details.
Do not place objects in
this area behind the projector
2ft(.6m)

1
INTRODUCTION
The Toshiba TDP-S2 and TDP-T1 multimedia projectors are spe-
cifically designed for multipurpose use. They generate crisp,
clear images using Digital Light Processing™ (DLP) technology,
and feature an M1-DA connector for easy, built-in digital/analog
and USB connectivity. They are easy to connect, easy to use, easy
to transport, and easy to maintain. The TDP-S2 has native SVGA
800x600 resolution, the TDP-T1 has XGA 1024x768 resolution.
The user interfaces of the two products are identical; information
in this user’s guide applies to both products.
NOTE: The TDP-S2 automatically
expands 640x480 images to
800x600. You can display these
images at their native resolutions
by turning off the Auto Resize fea-
ture. See “Resize” on page 24 for
more information.
Image Resolution
TDP-S2
The SVGA resolution of the TDP-S2’s projected image is 800x600.
The projector cannot compress screen resolutions above
1024x768. If your computer’s screen resolution is higher than
1024x768, reset it to a lower resolution before you connect the
projector.
TDP-T1
The XGA resolution of the TDP-T1’s projected image is 1024x768.
The projector cannot compress screen resolutions above
1024x768. If your computer’s screen resolution is higher than
1024x768, reset it to a lower resolution before you connect the
projector.
NOTE: The TDP-T1 automatically
expands 640x480 and 800x600
images to 1024x768. You can dis-
play these images at their native
resolutions by turning off the Auto
Resize feature. See “Resize” on
page 24 for more information.

2
I n t r o d u c t i o n
Compatibility
The projector is compatible with a wide variety of computers and
video devices, including:
•IBM-compatible computers, including laptops, up to 1024x768
resolution.
•Apple®Macintosh®and PowerBook®computers up to
1024x768 resolution.
NOTE: The projector is
compatible with 1080i and 720P
HDTV formats.
•Most standard VCRs, DVD players, HDTV sources, camcord-
ers and laser disc players.
Unpacking the Projector
The projector comes with the items shown in Figure 1. Check to
make sure all are included. Contact your Toshiba dealer imme-
diately if anything is missing.
If you are experienced in setting up presentation systems, use the
Quick Start card that was included in the shipping box. For com-
plete details on connecting and operating the projector, refer to
this User’s Guide.

3
FIGURE 1
Shipping box contents
1. TDP-S2 or TDP-T1 projec-
tor + lens cap
7. PR Lite computer cable
2. Soft carry case 8. Audio cable adapter
3. User’s Guide, Quick Start
card, and CD
9. Mac adapter
4. Power cord 10. Composite video cable
5. Remote control 11. Audio cable
6. M1-DA analog computer
cable
12. S-video cable
12
3
4
5
6
7
9
10 12
8
11

4
I n t r o d u c t i o n
FIGURE 2
Side view of projector
Usage Guidelines
•Do not look directly into the projection lens when the lamp is
turned on. The bright light may harm your eyes.
• Do not block the grills on the projector. Restricting the air flow
can cause it to overheat and turn off. If this happens, you must
wait a minute before attempting to turn it back on.
• Handle the projector as you would any product with glass
components. Be especially careful not to drop it.
• Avoid leaving the projector in direct sunlight or extreme cold
for extended periods of time. If this happens, allow it to reach
room temperature before use.
•Transport the projector in a vendor-approved hard or soft case;
refer to your Toshiba dealer or projectors.toshiba.com for more
information.
connector panel
speaker
focus ring
zoom ring
power
cord
connector
keypad
Security
power
button
lock

5
If You Need Assistance
The first place to look for help is in this manual. Be sure to check
the guidelines in “Troubleshooting” on page 37.
Please contact your Toshiba dealer for details.

6
I n t r o d u c t i o n