TotalGym.com | 858 586 6080
© 2017 Total Gym Global Corp. All rights reserved. 5113-02
ACCESSORIES | ENCOMPASS MODELS
SLIDE DISTANCE REGULATOR
1 2
STEP 1. Make sure there are no objects between the top of the
tower and where the Slide Distance Regulator (SDR) buckle
loop will rest on the tower cross arm, including cables, lock
pin, pulleys, etc. STEP 2. Open one buckle loop and slide it
around the tower, positioning the buckle loop as low as possible
against the tower cross arm. If there is a detent pin, make sure
the buckle strap sits between it and the tower.
INSTALLING BUCKLE LOOP ON TOWER
STEP 3. Lace the short end of the strap from the glideboard
through the bottom of the buckle by inserting one end of the
strap through the back slot of the buckle and then loop it
down through the front slot of the buckle and pull towards the
glideboard. STEP 4. Now pull the strap until the glideboard
motion limit is as desired. HINT: The glideboard is shown pulled
up from the bottom by the strap with the left hand.
3 4 2
STEP 1. Grab the remaining buckle loop. Move the glideboard
up out of the way and slide the other buckle strap under the
lower rail base from the inside of the rails so the buckle is
facing up on floor facing tower as shown. STEP 2. Wrap the
buckle strap over the rail base and... FOLLOW ARROW FROM
STEP 2 TO STEP 3
INSTALLING BUCKLE LOOP ON RAIL BASE
1
3 4
STEP 3. Insert the buckle through the loop and pull it tight
as shown. STEP 4. Take the long end of the strap from the
glideboard and pull it under the glideboard and over the silver
crossbar. Then pull the long strap towards the rail base of the
unit. STEP 5. Thread strap through buckle as directed before.
NOTE: The strap should not be twisted or entrapped under the
rail hinge or around the gas struts. STEP 6. Push the glideboard
to the desired upper motion limit and hold it there. Then pull the
end of the strap from the buckle until there is no slack in the
buckle loop and strap. Test the motion of the glideboard with
your hands. The buckles should hold a rm grip on the straps
from the glideboard.
5 6
THE SLIDE DISTANCE REGULATOR IS NOW READY TO USE.
Increase or decrease the range of motion by adjusting the
length of the strap through the buckles.
NOTE: Discontinue use if any part of the Slide Distance
Regulator becomes damaged or altered in any way.
