Totem PLYROOM Panca Bambina User manual

PLYROOM
Panca Bambina
Thank you for choosing this product to be a part of your home.
Each Plyroom piece is made for life from sustainably forested materials. Your choice is helping support
environmental initiatives through our contribution of 1% of our sales revenue to 1% for the Planet.
Share your space with us #plyroom
@plyroom
www.plyroom.com.au
INTENTIONALLY SIMPLE
& HONEST DESIGN
This product is designed with a modern interpretation of mortise and tenon joinery,
the oldest and strongest form of joinery used by carpenters for thousands of years.
The precise interlocking parts are displayed throughout, and the pieces fit together
like a jigsaw, emphasising the characteristics of the natural materials used.
Each mortice and tenon join is locked in place with a
handmade oak dowel.
MINIMAL PACKAGING
You might notice that your item is packaged simply. This is intentional to minimise
waste as much as possible. The plastic wrapping used can be recycled at many
recycling centres rather than going to landfill.
ASSEMBLING YOUR FURNITURE
→Do
We ask that you take your time in assembling this piece of furniture. All pieces are
designed to lock together with precision.
Use a mallet to press mortise and tenon joins together so they are flush. If you don’t
have a mallet a hammer covered with a soft towel is fine.
Check all joins are flush before inserting the oak dowels.
Use a hammer to tap dowels in and fasten pieces together. Make sure the dowel is
straight before you hammer.
→Don’t
Use a mallet on the timber dowels as the soft head of the mallet will cause them to
snap.
This product has been designed and made by
Totem Italia exclusively for Plyroom.

ASSEMBLY INSTRUCTIONS
→Build the bench
Insert the 2 x A1 parts into the openings on the back piece, B1. Push
both A1 pieces in until they are completely united with B1. Repeat this by
pushing part B2 onto the frame you have just created. Take note that the
ledge on B2 needs to be on the inside of the structure.
PARTS
Place part A2 into C2, and lock in place underneath by inserting the small
plug F into the opening at the base,
Take C2/A2 piece you have just made and place inside the structure onto
the ledge of the B parts.
Insert the 2 small D pieces into the openings on either side of part C1;
place C1 onto the frame, aligning with the similar shape on parts A1. Insert
the 2 large plugs (g) through parts A1 and D. Insert the 2 plugs H into the
A1 sides.
PRODUCT CARE
For general care we recommend dusting with a clean, dry cloth, or
wiping down with soft cloth wrung dry from plain water (leaving the
surface dry after cleaning). Avoid detergents or solvents of any type.
IMPORTANT!
→Disassembling your frame
This piece is designed to be disassembled when required. Please
note that when disassembling, a hammer must be used to remove the
dowels. ALWAYS hold the hammer in line with the grain of the timber
panel it fastens and use the prongs of the hammer to lever the dowel
out slowly. If this step is not followed it will result in breakage of the
dowel.
Once the timber dowel is removed the mortise and tenon pieces will
come apart with some gentle tapping with a mallet.
There will be 2 spare dowels in your box to keep as spares.
A1 x 2
B1 x 1
B2 x 1
C1 x 1
D x 2
A2 x 1
C2 x 1
G x 2 large plugs
F x 1 small plug
H x 2
Wooden dowels
D
A1
C1
B1
B2
A2
insert H plug