
Toyota Motor Europe NV/SA
Bourgetlaan 60
B-1140 Brussels Installation checksheet
Version date: 15/09/2006
Corolla Hatch back E12
Mobility project : swivel seats
Operator: Date:
VIN:
Before installation
Box content OK
Serial number Lift Up seat
During installation
VSC ECU and sensor do not interfer with swivel seat RHD
Earth connection firmly fitted
Foam around connectors
B+ terminal in fuse box has proper connection
Don't damage connectors during handling
Front seat bolts on torque 37Nm
After installation
All parts installed according to manual Seat (rail) covers well fitted L R
SRS warning light comes on when
turning key to 'ON' position
SRS warning light goes off after
approximately 6 seconds
LR
Passenger detection light working Wiring under seats strapped to original wiring
Warning lights Inspect no damage on the covers / fabric L R
Seat heaters working Plastic covers are well fitted ?
Tune, seek radio Stickers well fitted ?
Volume up and down (from steering
wheel)
Correct position comes on the screen
automatically (after satellite reception,
with full map navi) Arm and foot rest working ok ?
Console is well aligned with dashboard,
no gaps Front rear movement is OK ?
Cigarette lighter operating Swivel movement is OK ?
Cigarette lighter illumination Force for operating swivel lever is OK ?
Audio illumination
Electric Mirror working
No traces of wiring No NVH while driving ?
No scratches on dash board
VSC signal goes off
Wiring under seats leaves enough room
for movements, no obstruction when
moving forward/backward, up/down. No interference
with swivel operation
System (seat operation) Back side Front seats
Don't squeeze wires
Seat /
headrest
General
Dashboard
Supervisor check: