TP-Link TPL-WPA4220 User manual

TL-WPA4220
AV600 Powerline Wi-Fi Extender
REV1.1.2
1910012017

COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice. is a registered trademark of
TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered
trademarks of their respective holders.
No part of the specifications may be reproduced in any form or by any means or used to make any
derivative such as translation, transformation, or adaptation without permission from TP-LINK
TECHNOLOGIES CO., LTD. Copyright © 2016 TP-LINK TECHNOLOGIES CO., LTD. All rights
reserved.
http://www.tp-link.com

FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1）This device may not cause harmful interference.
2）This device must accept any interference received, including interference that may cause undesired
operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user’s authority to operate the
equipment.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located or operating in conjunction with any
other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile
Configurations. The antennas used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.”
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio interference, in which
case the user may be required to take adequate measures.

RF Exposure Information
This device meets the EU requirements (1999/5/EC Article 3.1a) on the limitation of exposure of the
general public to electromagnetic fields by way of health protection.
The device complies with RF specifications when the device used at 20 cm from your body.
Canadian Compliance Statement
This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following
two conditions:
1）This device may not cause interference, and
2）This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes :
1）l’appareil ne doit pas produire de brouillage;
2）l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, meme si le brouillage est
susceptible d’en compromettre le fonctionnement.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your
body.
Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de
distance entre la source de rayonnement et votre corps.
Industry Canada Statement
CAN ICES-3 (B)/NMB-3(B)
Korea Warning Statements
당해 무선설비는 운용중 전파혼신 가능성이 있음.
NCC Notice
注意！
依據 低功率電波輻射性電機管理辦法
第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加
大功率或變更原設計之特性或功能。
第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通行；經發現有干擾現象時，應立即停用，
並改善至無干擾時方得繼續使用。前項合法通信，指依電信規定作業之無線電信。低功率射頻電機需忍受
合法通信或工業、科學以及醫療用電波輻射性電機設備之干擾。

BSMI Notice
安全諮詢及注意事項
請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。
清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。
注意防潮，請勿將水或其他液體潑灑到本產品上。
插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。
請勿將本產品置放於靠近熱源的地方。除非有正常的通風，否則不可放在密閉位置中。
請不要私自打開機殼，不要嘗試自行維修本產品，請由授權的專業人士進行此項工作。
Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам
нормативних документів та вимогам, що передбачені чинними законодавчими актами України.
Safety Information
When product has power button, the power button is one of the way to shut off the product; when
there is no power button, the only way to completely shut off power is to disconnect the product or
the power adapter from the power source.
Don’t disassemble the product, or make repairs yourself. You run the risk of electric shock and
voiding the limited warranty. If you need service, please contact us.
Avoid water and wet locations.
Explanation of the symbols on the product label
Symbol Explanation
Class II equipment
Indoor use only
AC voltage

RECYCLING
This product bears the selective sorting symbol for Waste electrical and electronic
equipment (WEEE). This means that this product must be handled pursuant to
European directive 2012/19/EU in order to be recycled or dismantled to minimize its
impact on the environment.
User has the choice to give his product to a competent recycling organization or to
the retailer when he buys a new electrical or electronic equipment.

Important Safety Instructions
1. Do not open this product or attempt to service it; it may expose you to dangerous high voltage or
other risks.
2. Do not operate this product near water.
3. Do not place or operate this product near a radiator or a heat register.
4. Do not expose this product to dampness, dust or corrosive liquids.
5. Do not connect this product or disconnect it from a wall socket during a lightning or a thunderstorm.
6. Do not block the ventilation slots of this product, for insufficient airflow may harm it.
7. Do not put anything on this product.
8. Plug this product directly into a wall socket (100-240V~, 50/60Hz). Do not use an extension cord
between this product and the AC power source.
9. When plugging this product into a wall socket, make sure that the electrical socket is not damaged,
and that there is no gas leakage.
10. Place the connecting cables properly so that people won’t stumble or walk on it.
11. This product should be operated from the type of power indicated on the marking label. If you are not
sure of the type of power available, consult the qualified technician.
12. Unplug this product from the mains and refer the product to qualified service personnel for the
following conditions:
If liquid has been spilled on the product
If the product has been exposed to rain or water
13. Unplug this product from the wall socket before cleaning. Use a damp cloth for cleaning. Do not use
liquid cleaners or aerosol cleaners.
14. The specification of the fuse is T4AL250V. To avoid damage, please do not change the fuse.
15. The Operating temperature is 0℃~40℃(32℉~104℉). The Storage temperature is -40℃~70℃
(-40℉~158℉).

CONTENTS
Chapter 1 Introduction........................................................................................................1
1.1 System Requirement................................................................................................... 1
1.2 Conventions........................................................................................................................1
1.3 Physical Interface........................................................................................................... 2
1.4 LED Indicator.....................................................................................................................2
Chapter 2 Hardware Connection............................................................................... 4
2.1 Before You Begin............................................................................................................ 4
2.2 Plug and Play ....................................................................................................................4
2.3 Wi-Fi Clone Button for Super Range Extension.................................... 7
Chapter 3 Configure the Device................................................................................. 9
3.1 Login.........................................................................................................................................9
3.1.1 For Wired Connection................................................................................................. 9
3.1.2 For Wireless Connection ....................................................................................... 10
3.2 Status .....................................................................................................................................12
3.3 Network ................................................................................................................................13
3.4 Wireless ...............................................................................................................................13
3.4.1 Wireless Settings........................................................................................................... 14
3.4.2 Wireless Security........................................................................................................... 15
3.4.3 Wireless MAC Filtering............................................................................................ 18
3.4.4 Wireless Advanced...................................................................................................... 20
3.4.5 Wireless Statistics......................................................................................................... 21
3.5 Powerline ............................................................................................................................22
3.5.1 Network Settings............................................................................................................ 22
3.5.2 Station Settings ............................................................................................................... 22
3.6 System Tools.................................................................................................................... 24
3.6.1 Firmware Upgrade ....................................................................................................... 24
3.6.2 Factory Defaults.............................................................................................................. 25
3.6.3 Backup & Restore......................................................................................................... 26
3.6.4 Reboot...................................................................................................................................... 26
3.6.5 Password............................................................................................................................... 27
3.6.6 System Log.......................................................................................................................... 27

Chapter 4 Connecting to Wireless Network ................................................. 29
4.1 In Windows 7 ...................................................................................................................29
4.2 In Windows Vista..........................................................................................................31
4.3 In Windows XP...............................................................................................................33
4.4 In Windows 8 or Windows 10.............................................................................33
Chapter 5 Pair Button and Reset Button......................................................... 36
5.1 Pair (Secure with 128 bits-AES).......................................................................36
5.2 Setting Up a Powerline Network with the Pair Button .................... 36
5.3 Reset...................................................................................................................................... 37
Appendix A: Troubleshooting Guide................................................................... 38
Appendix B: Specifications.......................................................................................... 39

TL-WPA4220
AV6 00 Powerline Wi-Fi Extender
1
Chapter 1 Introduction
Congratulations on your purchase of this outstanding AV600 Powerline Wi-Fi Extender. This device is
not only a 600Mbps powerline Ethernet adapter which transforms your house’s existing electrical wiring
into a ubiquitous networking infrastructure, but also a 300Mbps Wi-Fi Access Point which creates a
wireless network allowing for greater range and mobility.
As a powerline Ethernet adapter, it uses the existing power lines installed in a home as a path to
transmit digital data, voice, audio and video between devices. Simply plug this AV600 Powerline Wi-Fi
Extender into an ordinary AC power outlet, and then your Cable/xDSL broadband connection or existing
Ethernet (LAN) network can be easily extended to any other electrical outlet on the same electrical
circuit of a house. With powerline data rates of 600Mbps, full multimedia application can easily be
supported throughout the whole house.
As a Wi-Fi Access Point, it can transmit wireless data at the rate of up to 300Mbps. With multiple
protection measures including SSID broadcast control, wireless LAN WEP encryption, and Wi-Fi
Protected Access (WPA2- PSK, WPA-PSK), the device delivers complete data privacy.
It supports an easy, Web-based management utility. Even though you may not be familiar with the
device, you can easily configure it with the help of this Guide. The adapter adds three new functions
which are found to be useful.
1. Connection with a new unassociated device via the Pair button.
2. Reset to default settings via the Reset button.
3. Wi-Fi Clone via Wi-Fi Clone button.
1.1 System Requirement
a) At least two power outlets (100-240V~, 50/60Hz) with standard home power wiring
b) A computer with the following:
Operating System of Windows XP/Vista/7/8/10
Operating System with TCP/IP installed
Pentium III compatible processor and above
Ethernet LAN card installed with TCP/IP protocol
64 MB RAM or more
50 MB of free disk space (Minimum)
1.2 Conventions
The extender, or TL-WPA4220, or device mentioned in this User Guide stands for TL-WPA4220 AV600
Powerline Wi-Fi Extender without any explanations.
Parameters provided in the pictures are just references for setting up the product. They may differ from
the actual situation.
You can set the parameters according to your demand.