TP-Link TL-MR6400 User manual

TP Link TL-MR6400 Router Setup Guide
1. Hardware Setup
a. Insert SIM card
b. Connect the 4G LTE antennas
c. Power up the router
d. Connect to the router either through wired connection or wireless connection.
See included router documentation for details.
2. PC Setup
a. Open a web browser - ideally Chrome
b. Login using http://tplinkmodem.net
c. Username: admin and Password: admin
3. Router Quick Setup
a. Click on Quick Setup  on left hand side tab
b. Change timezone to relevant locale
c. Click create to enter a new profile for the dial-up (Cell phone/SIM card)
internet connection
i. For 2degress network:
1. Profile name: 2degrees
2. PDP Type: IPV4
3. APN Type: Static
4. APN: internet
5. Username: blank
6. Password: blank
7. Authentication Type: CHAP
ii. For Vodafone network:
1. Profile name: Vodafone
2. PDP Type: IPV4
3. APN Type: Static
4. APN: vodafone
5. Username: blank
6. Password: blank
7. Authentication Type: CHAP
iii. For Spark:
1. Profile name: Spark
2. PDP Type: IPV4
3. APN Type: Static
4. APN: internet.telecom.co.nz or m2m
5. Username: blank
6. Password: blank
7. Authentication Type: CHAP
File: TP-Link TL-MR6400 Router Setup
1 of 2
EHL1706-1-A-1

d. Click save and next
e. Change the Wireless Network Name/SSID to a name of your choosing
f. Enter a Wireless Password
g. Click next
h. Click Finish (If you are connected over wireless, you will need to reconnect to
the new SSID to proceed)
4. Administrative Setup
a. Go to Network  , Lan  , and set IP address to: 192.168.64.1 (router will reboot on
Save)
b. Go to System Tools  , Password  and set a new password for the admin user to
C0nnect0r(or a password of your choice. Keep a record of this password
for future reference)

5. DHCP Setup [optional]
a. Click on DHCP  (left hand side tab)
b. In DHCP settings, set:
- Primary DNS  to: 8.8.8.8
- Secondary DNS  to: 8.8.4.4
6. This completes the configuration process.
-END-
File: TP-Link TL-MR6400 Router Setup
2 of 2
EHL1706-1-A-1