TP-Link TL-SF1005P User manual

Connection
7106508149 REV1.0.1
Installation Guide
5-Port 10/100Mbps Desktop Switch with 4-Port PoE
LED Explanation
Power
On: Power on
O: Power o
Package Contents: TL-SF1005P, Power Adapter, Power Cord, Feet and Installation Guide.
TL-SF1005P
PoE MAX
Note: 1. PoE ports can also connect to non-PoE devices, but only transmit data.
2. Maximum PoE power is 15.4W for each PoE port and 58W for all PoE ports.
DC Power Adapter
AC Power Cord
IP Camera AP IP Phone
PoE Devices
Router
LAN Port WAN Port
Internet
Ethernet Ports (1-5)
PoE Ports (1-4)
Link/Act and PoE Status
Power
PoE Max
On: 51W≤Total power supply < 58W
Flashing: Total power supply ≥ 58W
O: Total power supply < 51W
On: Link present but no
activity
Flashing: Transmitting/
receiving data
O: No link
On: Providing PoE power
Flashing: Current-overload/
Short-circuit
O: Not providing PoE power

Frequently Asked Questions (FAQ)
The Power LED should be lit when the power system is working normally.
If the Power LED is not lit, please try the following:
A1: Make sure the AC power cord is connected to the switch with power
source properly.
A2: Make sure the voltage of the power supply meets the requirements
of the input voltage of the switch.
A3: Make sure the power source is ON.
Q1. Why is the Power LED not lit?
Please try the following:
A1: Make sure that the cable connectors are rmly plugged into the
switch and the device.
A2
: Make sure the connected device is turned on and works normally.
A3
: The cable must be less than 100 meters long (328 feet).
Q2. Why is the Link/Act LED not lit while a device is
connected to the corresponding port?
IEEE802.3i, 802.3u, 802.3x, 802.3af
CSMA/CD
5 10/100Mbps RJ45 Ports, Auto-Negotiation MDI/MDIX
PoE Ports: Port1-Port4, Total Power Supply:58W
10BASE-T: UTP category 3, 4, 5 cable (maximum 100m);
EIA/TIA-568 100Ω STP (maximum 100m)
100BASE-TX: UTP category 5, 5e cable (maximum 100m);
EIA/TIA-568 100Ω STP (maximum 100m)
1Gbps
2K
Store-and-Forward
Automatically learning, automatically aging
External Power Adapter
Input: 100-240VAC, 50/60Hz Output: 48VDC /1.25A
Standard
Protocol
Interface
Network Media (Cable)
Switching Capacity
MAC Address Table
Transfer Method
MAC Address Learning
Power Supply
General Specications
Specications
This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may
be required to take adequate measures.
CE Mark Warning
Do not use this product near water, for example, in a wet basement or near a swimming pool.
Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
SAFETY NOTICES
Cautions
Industry Canada Statement
CAN ICES-3 (B)/NMB-3(B)
© 2018 TP-Link
Q3. Why is port 4 not supplying power for PoE devices?
If connected PoE device’s total power consumption exceeds 58W, the
system will cut o the power to port 4. For example, port 1, 2 and 4 are
consuming 15.4W respectively, if an additional PoE device with 12W is
inserted to port 3, the system will cut o the power of port 4 to
compensate for the overload.
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
0˚C to 40˚C (32˚F to 104˚F)
-40˚C to 70˚C (-40˚F to 158˚F)
10% to 90%RH non-condensing
5% to 95%RH non-condensing
Environmental and Physical Specications
BSMI Notice
安全諮詢及注意事項
請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。
清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。
注意防潮，請勿將水或其他液體潑灑到本產品上。
插槽與開口供通風使用，以確保本產品的操作可靠並防止過熱，請勿堵塞或覆蓋開口。
請勿將本產品置放於靠近熱源的地方。除非有正常的通風，否則不可放在密閉位置中。
請不要私自打開機殼，不要嘗試自行維修本產品，請由授權的專業人士進行此項工作。
Explanation of the symbols on the product label
DC voltage
RECYCLING
This product bears the selective sorting symbol for Waste electrical and electronic equipment
(WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in
order to be recycled or dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling organization or to the retailer when
he buys a new electrical or electronic equipment.
Indoor use only
Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам нормативних документів та
вимогам, що передбачені чинними законодавчими актами України.
For technical support and other information, please visit
http://www.tp-link.com/support, or simply scan the QR code.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired
operation.
Any changes or modications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
FCC STATEMENT
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant
provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.
The original EU declaration of conformity may be found at http://www.tp-link.com/en/ce.
Wall Mountable
Distance Between
Mounting Holes
Ye s
52mm