Trail-Gear Creeper lock 302915-kit User manual

5356 PINE AVE • FRESNO, CA • 93727
USA TOLL FREE: 877.4X4.TOYS • WORLDWIDE: 559.252.4950
WWW.TRAIL-GEAR.COM
Creeper lock™ Beadlock Wheel Hub Cover
kit contents
302915-KIT (FOR 3-1/4”CENTER BORE JEEP TJ/JK WHEELS)
302916-KIT (FOR 4-1/4”CENTER BORE TOYOTA & JEEP CJ/YJ WHEELS)
302917-KIT (FOR 5-1/8”CENTER BORE 8-LUG WHEELS)
InstalLation Instructions

InstalLation Instructions
caution
1. Read all instructions completely and carefully before you begin.
2. Check to make sure the kit is complete and that no parts are missing (refer
to the Kit Contents List on the rst page of these instructions). If anything is
missing, please contact Trail-Gear at 559.252.4950.
3. Park vehicle on a clean, dry, at, level surface and block the tires so the
vehicle cannot roll in either direction.
4. Beadlocked wheels are intended for Off-Road use only.
5356 PINE AVE • FRESNO, CA • 93727
USA TOLL FREE: 877.4X4.TOYS • WORLDWIDE: 559.252.4950
WWW.TRAIL-GEAR.COM
recommended tools
Ratchet & Socket Set
Clean Cloth
Isopropyl Alcohol
Thin Wall 19mm/21mm Flip Socket (P/N 170003-KIT)

Creeper lock™ Beadlock Wheel Hub Cover
InstalLation Instructions
Clean the top surface of the Hub Cover thoroughly
with isopropyl (rubbing) alcohol. Dry the top of the
Hub Cover thoroughly with a clean cloth. NOTE: For
best results, Steps 1-3 should be done in a room
temperature or warmer (68°F minimum) environment.
step 1
Remove the backing from the dome label and apply to
the center of the Hub Cover.
step 2
Press down rmly on the label with your ngers to
ensure good adhesion. For best adhesion, keep the
Hub Cover in a room-temperature or warmer environ-
ment (68°F minimum) for 24 hours after applying the
label.
step 3
If supplied, install the provided O-ring onto the hub
cover. Otherwise, you may skip this step.
step 4
Install the hub cover into the center bore of the wheel
from the back side of the wheel.
step 5
Install the wheel onto your vehicle and torque the lug
nuts to the torque specied in your owner’s manual.
step 6

InstalLation Instructions
replacement & service parts: