TRAK RACER TR80 User manual

1
TR80
Manual

2
STEP 1
Let’s start building your new simracing rig!
Lay out all the individual parts as shown below

3
STEP 2
Attach the feet on the main beams and add the pictured parts as shown below
STEP 3
Add 10x nuts to the middle profiles before placing them inbetween as shown below
Note: make sure to break off the taps in the corner brackets with a flat screwdriver if
they don’t sit flush on the aluminium profile as shown on the next page

4

5
After completing step 1, 2, 3 and tightening the brackets your build should look like
this:

6
STEP 4
Add 2 profiles on top of the existing square as shown below
After adding the parts in step 4 your build should look like this:

7
STEP 4
Add the seat slider and brackets as shown below
Note: the middle leaver attached to the 2 rails should be bend outwards to fit both
ends of the rails
STEP 5
After fitting the leaver, test if the rails can slide easily as shown below

8
STEP 6
Now add the seat (GT style shown below) to the bracket and test if you can freely
adjust your seating position with the leaver. If this doesn’t go smooth adjust realign
the aluminium profile and try again.
STEP 7
Add the wheelmount support as shown below
Note: remove the red strips and add it later on in the build (step 16)

9
STEP 8
After tightening the bolts add the middle profile as shown below.
Make sure to add 4 extra nuts on the profile, facing the seat, top and bottom before
attaching it to the frame.
STEP 9
Attach the wheelmount to the frame, 8x nuts shown below should have already been
added in step 8

10
Before fully tightening the wheelmount see below for adjustability options.
Note: adjusting can also be done with the wheelbase mounted.
STEP 10
Add the shifter profile as shown below.
Note: right side is illustrated but you could also choose to mount if on the left side.

11
STEP 11
Add the shiftermount as shown below
The shiftermount can be adjusted to your preferrence as shown below

12
STEP 12
Add pictured parts as shown below
STEP 13
Add the pictured parts to complete the bottom frame as shown below.

13
STEP 14
Add the side structure of the pedalplate
Add each side like shown below
Now slide in the nuts to attach the middle profiles

14
STEP 15
Add the pedalplate as shown below
The pedalplate can be adjusted towards your likings as shown below

15
Almost there!
Now its time to personalize the seating/wheelmount and pedalplate towards your
likings. Every component can be adjusted as shown below.
STEP 16
When you are done adjusting add the red striping.
Note: you need to cut the red striping on several points in order for it to fit your
custom adjustments.
STEP 17
Add end caps on the outer ends of the profile and brackets

16
That’s it, you are done!
We wish you a lot of fun with your freshly built simulator.
Thank you for choosing Trak Racer.