Trans instruments ELECTROLYZER User manual

4,1,4,1,2,3,2,3
OPERATION MANUAL
ELECTROLYZER 2i
A powerful tool to demonstrate purity
of Reverse Osmosis water

IN
TRODUCTION
The ELECTROLYZER is specially designed as a
powerful visual demonstration tool to compare R.O.
purified water and untreated water through the
precipitation of solid*, making it the easiest way to
explain the unseen dissolved solid in portable water.
(Note: *Test results do not suggest that untreated water were
unsafe for consumption)
IMPORTANT:
READ WARNING INSTRUCTIONS
BEFORE USE
SIMPLE OPERATION
1. After unpacking the unit, use a dry cloth to wipe off
the layer of protective oil on each of the electrode.
2. Screw in each electrode on the base of the unit
according to the fitting screw size.
3. Fill a glass with tap water and another with R.O.
purified water.
4. Ensure that the switch is OFF and dip two of the
electrodes in each glass of water.
5. Plug the power plug into the A/C socket than
switch ON the unit.
6. The switch will light up. The untreated water will
gradually boil and solid precipitated; while the R.O.
water will remain crystal clear and cool.
7. Switch OFF the unit once the result is shown.
8. Unplug from the power socket then wipe-dry the
electrodes before storing away.
9. A thin layer of oil applied on the electrodes would
prevent rust developing on it.

SIMPLE MAINTENANCE
1. After several uses, rust may develop on two of the
electrodes. Use sandpaper to remove the rust.
Replacement electrodes are also available from
your supplier.
2. If the fuse were blown due to high TDS in water,
replace the fuse with only 3 Amp fuses.
3. Always remember to unplug unit from A/C socket
while making maintenance.
ELECTRODES
Unscrew by turning anti-clockwise
for electrode replacements
FUSE HOLDER
Unscrew by turning
anti-clockwise for fuse
replacements.
Use only 3A fuse
ON/OFF SWICH
POWER PLUG

**WARNING
THIS IS A HIGH VOLTAGE DEVICE.
USE WITH EXTRA CAUTION
♦Never leave the unit unattended while it is
connected to the power socket.
♦Never touch electrodes or place them on the
table while the unit is connected to the power
socket.
♦Never leave the unit ON for more than 5
minutes.
♦Do not test water with TDS exceeding 300ppm.
Dilute water with R.O. water first.
♦ Do not use fuse above 3 Amp. This is to
protect the electrical circuit.
** Personal injuries may result if user does not take all
necessary precautions.
** The manufacturer is not responsible for any injuries, which
may result from the use of the product.
MADE IN SINGAPORE
REV-4