TRENDnet TPE-102S User manual

TRENDnet's TPE-102S Power over Ethernet Splitter provides an
innovative and cost effective solution to a variety of Ethernet devices
such as VoIP phones or Wireless Access Points. Reduce costs by
using existing CAT5 cable to deliver both power and data where
power source is difficult to obtain.
TPE-102S (b1)
TEW-503PI (07-28-2005) TPE-102S (b1)
rev:11.07.2005
• IEEE 802.3af Power over Ethernet (PoE) Standard Compliant
• Support up to 11W at 5V DC or 12W at 12V DC
• Converts Non-PoE devices with Power Over Ethernet Support
• Advanced Auto-Sensing Algorithm enables the ability to draw power from 802.3af PSE (Power Source
Equipment) Devices
• High Safety Standards with Short Circuit Protection
• Supports Power Detection and Classification
• Auto Disconnection for Over Voltage or Under Voltage Situation
• 5-Year Warranty
FEATURESFEATURES
Power over Ethernet (PoE) Splitter

Network Media
Diagnostic LEDs
Protocol
Topology
Ports
Switch
Power Consumption
Temperature
Humidity
Weights
Certification
Dimensions (LxWxH)
• IEEE 802.3 10Base-T • IEEE802.3u 100Base-TX • IEEE 802.3af Power over Ethernet
• 2.5mm / 0.1” Diameter on the Connector (Center Positive)
• 10Mbps: Cat 3,4,5 Unshielded/Shielded/Screened Cable
• Power In: 48V (Green)
• Power Out: 5V (Green) / 12V (Amber)
• Storage: -10°~ 70°C (14°F~ 158°F)
• 87 x 85 x 24mm (3.425 x 3.35 x 0.95 inches) (L x W x H)
• 100Mbps: Cat 5, 5E, 6 Unshielded/Shielded/Screened Cable
• CSMA/CD
• Star
• 1 x PoE-IN Port (Data + Power)
• 15.4 watts (max)
• 1 x Data-OUT Port (Data only)
• Switch between 5V and 12V
• DC Output 5V/2.2A or 12V/1A
• Operating: 0°~ 40°C (32°F~ 104°F)
• 10%- 90% (non-condensing)
• FCC, CE
• 156g (0.35 lb)
Power
Jumper Cable
Standards
Hardware
TRENDnet is a registered trademark. Other Brands and product names are trademarks of their respective holders. Information provided in this document pertain to TRENDnet
products and is subject to change at any time, without notice. For the most recent product information please visit
http://www.trendnet.com.
©
Copyright TRENDnet. All Rights Reserved.
Power over Ethernet (PoE) Splitter
TPE-102S (b1)
RELATED PRODUCTSRELATED PRODUCTS
PACKAGE CONTENTSPACKAGE CONTENTS
TPE-S88
TPE-101I Power over Ethernet (PoE) Injector
• Power Jumper Cable
• Cat.5 Cable (60cm/23.6inches)
16-Port 10/100Mbps Web Smart PoE Switch
• TPE-102S
• Multi-Language User's Guide
ORDERING INFORMATIONORDERING INFORMATION
To Order Please Call:
1-888-326-6061
3135 Kashiwa Street,Torrance, CA 90505 USA
Tel: [phone]
Fax: [phone]
Web:
Email: [email protected]
www.trendnet.com
NETWORKING SOLUTIONSNETWORKING SOLUTIONS
SPECIFICATIONSSPECIFICATIONS
(TPE-101I)
Power over Ethernet Injector
Power over Ethernet Splitter
(TPE-102S)
(TPE-S88)
48VDC Power +
Ethernet Data
Power
Ethernet Data
48VDC Power + Ethernet Data
48VDC Power
Ethernet Data
48V DC Power
Power
Ethernet Data
48VDC Power + Ethernet Data
Ethernet Data
Powered Device which
uses 5V or 12V Power Input
(Wireless AP, Camera, etc.)
Power
Jack
16-Port PoE and
10/100Mbps Web Smart Switch
Power
Ethernet Data
48VDC Power + Ethernet Data
Power over Ethernet Splitter
(TPE-102S)
Power
(TPE-S88)
16-Port PoE and
10/100Mbps Web Smart Switch
Powered Device which
uses 5V or 12V Power Input
(Wireless AP, Camera, etc.)
PoE Ports
Ethernet Ports