TRENDnet TEW-731BR User manual

Table of Contents
English 1
1. Before You Start 1
2. Hardware Installation 2
3. Power-over-Ethernet Installation
Troubleshooting 10
Version 01.08.2010

1. Before You Start
Package Contents
• TEW-63 PAP
• Multi-Language Quick Installation Guide
• CD-ROM(Utility and User's Guide)
• AC Power Adapter (12V DC, 0.5A)
• Cat.5Ethernet Cable (0.6m / 2ft.)
System Requirements
• WebBrowser: Internet Explorer (6 or higher)
I. A computer with a network adapter or wireless adapter properly installed
• A routerwith an available network LAN port
• Anavailable DHCP Server - routers usually have a built-in DHCP server
• Powerover Ethernet (PoE) Switch (e.g. TPE- 0WS) (Optional)
• Injector(e.g. TPE-111GI) (Optional)
Note: The TEW-63 PAP only works with Power over Ethernet (PoE) devices that
follow the IEEE 02.3af standard.
1

2. Hardware Installation
Note:
1. Locate an optimum location for the Access Point. The best place for the Access Point
is usually at the center of your wireless network.
2. Disable any anti-virus and firewall programs before starting hardware installation.
3. For Power-Over-Ethernet installation instructions, please refer to section
3. Power-Over-Etherent installation.
For Windows Users
1. Insert Utility CD-ROM into your computer's
CD-ROM drive.
2. Click Run Setup.exe (Windows 7/Vista only)
3. Click Setup Wizard.
© T R E H D n E T
J
4. Click I accept the terms in the License
Agreement and then click Next.
2

6. Connect a RJ-45 cable from a LAN port on your
Router to the Ethernet port on your computer.
© T R eroriET
7. Connect the Power Adapter to the Access Point
and then to a power outlet and then click Next.
3

10. Select Access Point and then click Next.
Note: For AP Client setup, please refer to the
User's Guide for step by step instructions.
The User's Guide can be found on this
product's CD-ROM.
© T Setup Wizard
FRANQAIS

ESPAflOL
16. Select the desired WPA mode, enter
characters for your Pre-Shared key and then
click Next. For WPA-PSK or WPA2-PSK, the
Pre-Shared Key must be between and 63
ASCII or 64 HEX characters. Make sure to
copy down the Pre-Shared Key,
5

19. Click Configure to apply the settings.
20. Click Exit.
6

ESPAflOL
21. Click Yes to exit.
22. Connect the 2dBi detachable antennas to the
TEW-63 PAP
Note: to connect a wireless computer to the TEW-63 PAP, please refer to the first
question in the troubleshooting section.
Your Installation is complete
For detailed information regarding the TEW-63 PAP‘s configuration and advanced settings,
please refer to the Troubleshooting section, User's Guide on the Utility CD-ROM, or
TRENDnet's website at http://www.trendnet.com.
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
register your product Online at: www.trendnet.com/register
Thank you for choosing TRENDnet

3. Power-over-Et ernet Installation
Using the T W-638PAP with a Po switch
1. Connect a RJ-45 cable from the Power-Over-
Ethernet Switch (e.g. TRENDnet TPE- 0WS) to
the LAN port on the Access Point.
2. Verify that the wireless, LAN, and power LEDs
are on.
8
DEUTS H