TRENDnet TEW-635BRM - Wireless Router User manual

TEW-635BRM
H/W: V 1
Quick Installation Guide

Table of Contents
Table of Contents
Version 09.23.2008
Troubleshooting ........................................................................................ 9
English ...................................................................................................... 1
1
3
4
1. Before You Start
2. Hardware .......................................................................
3. .......................................................................
4. Setting up Encryption
.................................................................................
Installation ...
Configure The Modem
......................................................................... 7

Installation Requirements
Application
Package Content
1. Before You Start
English
1
?A working ADSL Internet Connection
?A computer with a wired or wireless network adapter properly installed
?Web Browser: Internet Explorer (5.5 or above)
?
?User's Guide CD-ROM
?Multi-Language Quick Installation
Guide
?1 x RJ-45 Ethernet Cable
?1 x RJ-11 Telephone Cable
?Power Adapter (12V DC, 1A)
TEW-635BRM
300Mbps
Phone Jack
Notebook with 300Mbps
Wireless N PC Card
(TEW-621PC)
300Mbps Wireless N
ADSL2/2+ Modem Router
(TEW-635BRM)
Workstation with 300Mbps
Wireless N PCI Adapter
(TEW-623PI)
ADSL Ready Line
Workstation with 300Mbps
Wireless N USB Adapter
(TEW-624UB)

English
2
Collect Internet Service Provider (ISP) Information
During the installation of your Wireless ADSL Modem Router, the Setup Wizard
will automatically detect your ISP connection type. If the router cannot detect
your ISP connection type, you can manually specify the connection type.
Please verify your DSL Internet broadband connection type with your ISP and
ensure you have all the information for one of the following connection types:
A. Dynamic IP connection
ADSL Modem parameters (VPI or VCI), if it cannot be detected automatically.
ISP may require you to use a particular Hostname or Domain name.
B. Static or Fixed IP connection
Internet IP Address:_____. _____._____._____ (eg. 215.24.24.129)
Subnet Mask: _____. _____._____._____
Gateway IP Address: ____. _____._____._____
Primary DNS:_____. _____._____._____
Secondary:_____. _____._____._____
ADSL Modem Parameters (VPI or VCI), if it cannot be detected automatically.
C. PPPoE or PPPoA Dynamic IP connection
Login User Name: _________
Password: ________________
ADSL Modem Parameters (VPI or VCI), if it cannot be detected automatically.
D. IPoA Static or Fixed (IP over ATM) connection
Internet IP Address:_____. _____._____._____ (eg. 215.24.24.129)
Subnet Mask: _____. _____._____._____
Gateway IP Address: ____. _____._____._____
Primary DNS:_____. _____._____._____
Secondary:_____. _____._____._____.
ADSL Modem Parameters (VPI or VCI), if it cannot be detected automatically.

English
3
2. Hardware Installation
4. Verify that the following panel lights
are on: Power, LAN, and WLAN.
If the lights are not on, press the
Power ON/OFF on the back of the
TEW-635BRM.
1. Connect one end of the RJ-45
cable to one of the TEW-635BRM's
LAN ports. Connect the other end
of cable to the computer's Ethernet
port.
2. Connect one end of the RJ-11
cable to the TEW-635BRM's ADSL
port. Connect the other end of the
cable to the phone jack.
3. Connect the AC Power Adapter to
the TEW-635BRM and then to a
power outlet.

English
4
3. Configure the Modem
Note: It is recommended that you configure the Modem from a wired computer.
2. Enter the user name and
password and then click OK.
By default:
User name: admin
Password: password
Note: User name and password is
case sensitive.
3. Click Setup Wizard.
1. Open your web browser, type
http://192.168.10.1 in the
Address bar, and press Enter.
4. Click Next. If you would like the
TEW-635BRM to auto detect your
internet connection, do not select
Enable MultiPVC.

English
5
5. Select Auto-detect, and then click
Next.
6. Configure the settings based on
information provided by your ISP.
Then click Next.
7. Configure the settings based on
information provided by your ISP.
Then click Next.
Note: For other connection methods, follow the on screen instructions after the
Auto Detection.
8. Please wait while the TEW-
635BRM reboots.
Note:
1: The example below is for Auto-detect. If the Setup Wizard could not
automatically detect your Internet connection, select Manual Selection and
input the information using the information provided by your ISP.
2. In the example below, the ADSL connection is PPPoE.

English
6
12. Open up your browser and enter
in a URL (e.g. www.trendnet.com)
to verify that you have Internet
connection.
9. Check the LEDs and then click OK.
10. Check Test Internet Connection,
and then click Finish.
11. Verify that the test has completed
successfully. Check that the
ADSL and Internet LEDs are lit.
Then click Close.

English
7
4. Setting up Encryption
1. Click Wireless. Select the Region,
enter the desired SSID and then
click Save.
2. Click Configure SSID1 to set up
Wireless Security.

English
8
3. This example below is WPA-PSK.
Select a Security System and
enter an encryption key in the PSK
field. Keep the Encryption value
as TKIP, click Save and then click
Close. For WPA-PSK or WPA2-
PSK, the Pre-Shared Key must be
between 8 and 63 ASCII or 64 HEX
characters. Make sure to copy
down the encryption key.
Your configuration is now complete.
For detailed information regarding the TEW-635BRM's configuration and
advanced settings, please refer to the Troubleshooting section, User's Guide
CD-ROM, or TRENDnet's website at http://www.trendnet.com.
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
register your product Online at: www.trendnet.com/register
Thank you for choosing TRENDnet

9
Troubleshooting
Q1:
A1:
I typed http://192.168.10.1 in my Internet Browser's Address Bar, but an error message
says “The page cannot be displayed.” How can I get into the TEW-635BRM's web
configuration page?
First, check your hardware settings again by following the instructions in Section 2.
Second, make sure the Power, LAN and WLAN lights are lit. Third, make sure your TCP/IP
settings are set to Obtain an IP address automatically (see the steps below).
1. Go into the Control Panel and double-
click the Network Connections icon,
right-click the Local Area Connection
icon and then click Properties.
2. Click Internet Protocol (TCP/IP) and
then click Properties. Then click on
Obtain an IP address automatically.
Fourth, reset the TEW-635BRM. To reset the TEW-635BRM, press the WPS and the WIRELESS
ON/OFF button simultaneously for 8 seconds, then let go.
The Modem does not auto-detect my DSL connection. What should I do?
First, verify that your DSL account is activated. Second, make sure all the cables are
properly connected (see Section 2). Third, in Section 3, select manual selection in the Setup
Wizard and configure the Modem based on information provided by your ISP.
All the settings are correct, but I can not make a wireless connection to the Modem.
What should I do?
First, double check that the Wireless LED on the Modem is lit. If the Wireless LED is not
lit, press the WIRELESS ON/OFF button on the back of the Modem. Second, power cycle
the Modem. Unplug the power to the Modem. Wait 15 seconds, then plug the power back
in. Third, contact the manufacturer of your wireless network adapter. Make sure the wireless
network adapter is configured with the proper SSID. The default SSID of the TEW-635BRM
is TRENDnet635. If you have enabled any encryption on the Access Point, make sure to
configure the wireless network adapter with the same encryption key.
I forgot my login password. What should I do?
Press the WPS and the WIRELESS ON/OFF button simultaneously for 8 seconds, then
let go. This will return all settings to factory default.
If you still encounter problems or have any questions regarding the TEW-635BRM, please contact
TRENDnet's Technical Support Department.
Q2:
A2:
Q3:
A3:
Q4:
A4:

Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may
cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de
alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al
mencionado puede producir daños fisicos y/o daños al equipo conectado. El adaptador
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria
existente en el pais o zona de instalación.

Copyright ©2008. All Rights Reserved. TRENDnet.
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDnet’s website at http://www.trendnet.com/register
20675 Manhattan Place
Torrance, CA 90501
USA