READY, SET, PHASE!
Using your ToneBug Phaser
Insert a 9V alkaline battery or connect to a T-Rex Fuel Tank power
supply (not included).
Plug your guitar into the INPUT jack, and run a lead from the OUT-
PUT jack into your amp.
Use the RATE knob to set the speed of your modulation, and the
DEPTH knob to choose how “heavy” you want the eect to be.
Try switching between Modern and Vintage modes to get the tone
you’re looking for, and then set your overall output volume with the
LEVEL knob.
TECHNICAL SPECIFICATIONS:
Input Impedance @ 1KHz Higher than 1 M Ohm
Output Impedance @ 1KHz Lower than 1 K Ohm
Power supply 9V DC
Minimum Power supply Voltage 8V DC
Maximum Power supply Voltage 12,5V DC
Current Draw @ 9V DC 75 mA
Maximum input signal Vp/p 2,5 Vp/p
Battery Type 9V battery 6F22 Alkaline
Battery Life 0,5 to 1 Hours
External connectors Input Jack. Output Jack, 9V DC Jack (center
pin negative)
Controls On/O, Rate, Modern, Vintage, Depth
Depth 120 mm
Width 78 mm
Height 60 mm
Weight (excl. battery) 0,404 Kg