TREX Reptile User manual

REPTILE
USER MANUAL

CONGRATULATIONS
on your purchase of Reptile, a brand new member of the renowned
Replica family of delay pedals from T-Rex Engineering.
Reptile offers a full range of advanced delay features – including tape-
delay flutter simulation – in a compact, intuitively designed unit. And of
course it delivers loads of incredible warm tone that you’ll only find in a
T-Rex pedal.
Turn the page to learn about the controls on your Reptile. And please
handle it with care… because this baby bites!

TECHNICAL SPECIFICATIONS
Input Impedance@1KHz 434 KOhm
Output Impedance@1KHZ 26 Ohm
Power Supply 9V DC (Power tool 9)
Minimum Power supply Voltage 8,5V DC
Maximum Power supply Voltage 12,5V DC
Current Draw @ 9V DC 124mA
Maximum Input signal Vp/p Adjustable
Battery Type 9V battery 6F22
Battery Life 1/2 to 1 Hour
External Connectors Input Jack, Output Jack, 9V DC Jack
Controls On/Off, Modulation, Level, Time Echo
Repeat Flutter, Speed
Depth 120 mm
Width 100 mm
Height 55 mm
Weight (excl. battery) 0,430 kg
CONTROL YOUR REPTILE!
The main controls on your Reptile are the ECHO, REPEAT, TIME and LEVEL
knobs, while the FLUTTER DEPTH & SPEED knobs and the MODULATION
button provide further options.
ECHO determines the mix of direct and delayed signal. Turn it down for
a subtler natural effect, and crank it up for doubling or freaky long delay
effects.
The REPEAT knob lets you control the number of times a sound is re-
peated – from just once to a virtual infinity.
TIME determines the rate of your echo repeats and can be adjusted from
10 to 1,000 ms. TIP: to experiment, try tuning in a classic 50s slap-back
sound by combining a fast time with a low repeat value.
The FLUTTER DEPTH & SPEED controls let you simulate that great tape-
delay “warbled” effect, while the MODULATION button subtly alters the
character of your delay.
Note: The INPUT LEVEL knob on the side of your Reptile eliminates
overdrive distortion caused by too high an input signal. Keep it set just
below where the red light comes on.

RoHS
REACh
T-REX WARRANTY CONDITIONS
T-Rex oers a 2-year warranty on all our products. In the unlikely event of a
malfunction, please contact our technical support at info@t-rex-eects.com
before sending us the product for repair. When the product has been sent to
us at sender’s cost, we will repair or replace your product and send it back to
you - free of charge and usually within 3 weeks (shipping not included). The
product needs to be accompanied by a copy of your receipt, serial number,
return address, phone number, e-mail address and a brief explanation of
the problem. Please note that we cannot replace a product until we have
received it here in Denmark.
The warranty is lost if the product has been damaged by alteration, misuse,
accident, or neglect; or if the product has been repaired or serviced by
persons not authorized by T-Rex. Read more about warranty conditions at
www.t-rex-eects.com.
ABOUT T-REX
Based in Vejle, Denmark, T-Rex Engineering makes classic and sig-
nature eects pedals for the world’s best musicians. Our approach
blends hi-tech innovation with old-world craftsmanship – always
in the service of killer tone.
EU REGULATIONS • ENVIRONMENT PROTECTION
T-Rex accepts and follows the regulations and directives issued
by the EU. We nd these environment protecting regulations very
good, and we are happy to follow them.

ISSUED IN VEJLE, 2008
Lars Dahl-Jørgensen
Development Director
Sebastian Jensen
Production Director
T-Rex Engineering ApS
www.t-rex-eects.com