TRIBU VIS A VIS 01741 User manual

VIS A VIS LOUNGER WHEELS
ASSEMBLY INSTRUCTIONS
01741
VAVLW01 - 20-04-2016
Tribù nv
Langendijkstraat 5a
3690 Zutendaal
BELGIUM
www.tribu.com
[email protected]
Insert 1 x wheel and 1 x washer. Fix the leg with the small screw in the bearing.
Insert the glider into the hole in the bottom of the leg.
Repeat step 1 till 6 for the opposite leg.
5
6

CONTENT ASSEMBLY INSTRUCTIONS
2 x
Wheel
2 x
Threaded rod
2 x
Spring washer
2 x
Metal washer
6 x
Wood screw
2 x
Plastic washer
2 x
Short leg
Put the lounger upside down on a protective surface. Remove the glider from the leg
closest to the side table. Now unscrew the leg with a box spanner.
Remove the bearing from the short leg.
If the bearing is stuck, you can use a wheel to force it out.
Attach the short leg to the lounger using 1 x metal washer and 1 threaded rod.
Use a box spanner to x the short leg.
Insert the bearing and use 3 x woodscrew to x it. Then unscrew the small screw in
the bearing using a crosshead screwdriver
1
2
3
4