modway EEI–2930 User manual

︱ Page 1 of 3
EEI–2930
Hardware:
Component:
A Bolt M6x50mm
x 1
Thank you for purchasing the MODWAY COFFE TABLE!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the coffee table, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
D
Allen Wrench M4 x 1
Customer Service 908-368-1025 www.modwayfurniture.com
1. Top Table x2
2. Longest part Legs x1
3. Short part Legs x1
B
Screws x 24
C
Screwdriver x 1
1
2 3
COFFEE TABLE

Customer Service 908-368-1025 www.modwayfurniture.com
COFFEE TABLE
STEP 1:
STEP 2:
Please put back side of Top Table (1) on a carpeted or padded area.
Insert the Longest part Legs (2) into the metal hinges or metal support.
Insert the Short part Legs (3) through middle cut.
3
2
Insert 4 pieces of Screw (B) from metal hinges to the Longest Part Leg (2) and Short Part Leg (3) as shown.
Tighten it with Screwdriver (C), repeat the procedure to the other sides of the Legs. Insert Bolt (A) in the middle
wooden cut and tighten with Allen Wrench (D).
1
EEI–2930
2
1
BA x 1
D
x 1
B
x 24
C
x 1
A
A
B
B
B
B
B
C
D
Page 2 of 3

Customer Service 908-368-1025 www.modwayfurniture.com
COFFEE TABLE EEI–2930
Page 3 of 3
STEP 3:
Carefully turn over the assembled Coffee Table.
Assembly is complete. Your coffee table is ready to be used now!