Tronix 169-091 User manual

View instructions and
technical data also on
our website
Read these instructions & save for future use
Article number
Brand
169-091
Tronix Lighting
Type Track lighting
Contents of this product 1x 30W track spot meat
Technical datasheet Digitally available
on our webshop
Track spot | 3-phase | white |
COB 30W meat 24°

169-091
1. Turn off the power and remove the product and associated parts from the packaging.
2. Determine the location for installation and assemble the rail and selected accessories;
3. Place the adapter inside the rail and turn the knob 90º to secure it. Then turn the switch also 90, as shown in the
picture;
4. Check the complete installation. Should this be in order, you can reactivate the power.
This sturdy track spot features a strong COB LED chip to make your display
look its best. Also, this spotlight features a special light color to enhance the
color of meat.
Ideal for use in the supermarket or butcher.
Features
• Equipped with crisp COB-LED lighting;
• Combine with reflectors 169-075, 169-089 and 169-114 for different
light beams.
Off
On
Description
Installation

Before getting started with this product, it is advisable to check the order completeness and any damage. If this is the
case, please contact Tronix Lighting.

169-091
The CE mark indicates that this product complies with EU regulations on safety, health and environmental
protection;
The WEEE symbol stands for "Waste Electrical and Electronic Equipment Regulation," a directive on the
collection, recycling and recovery of electronic waste;
The Class I symbol indicates that this product is protected by means of the additional ground cable. This
cable is identified by the yellow/green jacket and is attached to this product.
Terms and symbols (as relevant to product)
Safety
Safety is a top priority at Tronix Lighting. Therefore, we heartily recommend that you follow the following steps closely:
• Keep this manual carefully for future reference;
•Choose a qualified electrician while installing, maintaining or inspecting this product;
• Never look directly into a light source to avoid possible eye damage;
• Ensure that the respective power group is always on non-active when the product is connected;
•Use only recommended combinations (LED drivers, controllers or dimmers) to avoid injury or damage to the product;
•The light source of this spot is not replaceable. Because of this, you must replace the entire fixture towards the end
of its lifespan and it is not recommended to open it.
Should a product not work properly after installation, or if the product exhibits
problems over time, it is advisable to check the following elements:
• Check the wiring and installation of your product;
• Check for the presence of interfering elements such as dust, water or other
electronics;
• If possible, try disconnecting the product and testing it in another location to
rule out a problem at the location;
• Should you be dealing with a WIFI-based product, check and reset your
router's settings.
Should the product still not work after testing, it is recommended to send it in for
inspection and/or repair. To do so, please contact Tronix Lighting using nearby
details and proof of purchase (packing slip).
Supplier:
Tronix Lighting B.V
Vluchtoord 41
5406 XP Uden, Netherlands
[phone]
[email protected]
Technical problems and repair
• The product is rated IP20. This means that the product is resistant to the penetration of solid objects >12.5 mm and
is not resistant to water or moisture.