True TP-Link RE350 User manual

Set up Access Point Mode for TP-Link RE350
1. Type http://tplinkrepeater.net or 192.168.0.254 on Browser, enter Username = admin /
Password = admin and press Login

2. Apop up to Create a new username and password, if don’t want to, click a Plus sign (x)
to close this window

3. On the top menu, select Settings

4. And choose Mode
5. A pop up to Switch Mode, select Internet Access Point and press Save

6. Press Yes again to confirm
7. The device is rebooting, wait for a while until 100%

8. Back to Status page again

9. At Settings page, on the left menu, select Network
Choose Obtain an IP address automatically, press Save
Choose DHCP Server: Auto and press Save

10.On the left menu, select Wireless and set up Wireless as desired
11.WPS : can set or not set

12.Status menu : if the customer doesn’t connect LAN cable from main Router to Access
Point, Internet status will show “disconnect”

13.If LAN cable connected from main Router to Access Point, internet status will show a
check mark at globe sign and IP Address obtained from main Router will be shown in
below table
14.Wireless client : to check connected client