Tsunami TSUNAMI-500 Manual

TSUNAMI-500 OPERATING AND MAINTENANCE
Page 1 of 9
1) Installation Setup
A) Power source:
The T-500 requires a Plug-in style 220V 50 AMP power source.
(An alternate Hardwired style power source is also available.)
B) Power hookup:
The Plug-in style power cord attaches as shown. Lift the cover plate and insert the plug.
C) Power On & Off:
In the lower-level section, the Power On & Power Off switch is located on the right side
of the power control box behind the filter door.
Move the switch to the “POWER ON” position.

TSUNAMI-500 OPERATING AND MAINTENANCE
Page 2 of 9
2) Simple Maintenance and Cleaning:
All filters should be checked at regular intervals prior to operation.
CAUTION: POWER DOWN THE T-500 BEFORE REMOVING ANY FILTERS.
(WATER CARBON FILTERS, AIR FILTERS AND OR UV FILTER LIGHTS)
A) Water Carbon and Spun Filter:
Remove and replace the water and spun filter after 3-6 months amount of water is
produced. The new filters can be found stored in the water collection basin.
Turn the filter housing clockwise to remove. Install the spun filter in the housing
marked “SPUN FILTER” and the carbon filter in the housing marked “CARBON FILTER”
and re-install the housings by turning counterclockwise until tight.

TSUNAMI-500 OPERATING AND MAINTENANCE
Page 3 of 9
Both filters can be found in the water catchment for shipping purposes.
B) UV Filter Lights (2 Required)
Remove and replace the UV Filter Lights once a year.
Carefully turn and slide the rubber cover from the end of the light filter housing.
Disconnect the black cover from the plug at the end of the light filter.

TSUNAMI-500 OPERATING AND MAINTENANCE
Page 4 of 9
Once the plugs have been disconnected remove the light filter from the outer case.

TSUNAMI-500 OPERATING AND MAINTENANCE
Page 5 of 9

TSUNAMI-500 OPERATING AND MAINTENANCE
Page 6 of 9

TSUNAMI-500 OPERATING AND MAINTENANCE
Page 7 of 9
C) Air Filters:
There are 2 types of air filters on the T-500. There are 4 air filter frames in the bottom
section. The air filter frames on the bottom section have paper filters.
The paper air filters on the T-500 should be checked regularly for dirt and dust
accumulation depending on air quality and the surrounding environment. To remove
the paper filter frames, lift up on the handle located near the bottom and slide the filter
frame up and pull out to remove.
.
The paper filters can be washed out by using a low-pressure water hose. After washing,
shake out the filter to remove excess water before re-installing.
Re-install the lower paper filters by placing the filter frame into the opening and slide
the filter frame up. Once the filter frame has cleared the bottom of the opening, let the
frame slide back down so it is held in by the bottom edge of the opening.
There are 4 filter doors in the upper section. The air filter doors in the upper section
have plastic fiber filters. To remove the doors on the upper section, turn the door latch
and open the door. Then lift the door up off the hinges. The fiber filters can also be
washed out by using a low-pressure water hose.

TSUNAMI-500 OPERATING AND MAINTENANCE
Page 8 of 9
Re-install the upper fiber filter frames by sliding the door hinges down on to the hinge
pins and turn the latch to secure the door.
3) Water discharge hookup:
Attach one end of a hose to the discharge hookup on the T-500 and the other end to a
collection bladder or to a collection container preferred by the user.
4) Power Shutdown:
Find On & Off switch located in the lower level on the right side of the power control box
behind the filter door. Move the switch down to the “Power Off”location. If using an
attachable power cord, remove the power cord from the power plug-in.
5) Troubleshooting Guide:
A. Once the power is turned on and the T-500 is running, make sure the circulation pump
is not running prior to the water storage tank filling up.
B. Circulating fans should be running when the power switch is on.
C. Exhaust fan should turn on once the compressor starts running.

TSUNAMI-500 OPERATING AND MAINTENANCE
Page 9 of 9
6) Additional Support:
Tsunami Products, Inc.
P.O. Box 566
1711 N. Madson St.
Liberty Lake, WA. 99019, USA
On-line Support
Phone: [phone]
Email: [e-mail]